首页> 外文期刊>Journal of Medicinal Chemistry >Design and synthesis of conformationally constrained Grb2 SH2 domain binding peptides employing alpha-methylphenylalanyl based phosphotyrosyl mimetics
【24h】

Design and synthesis of conformationally constrained Grb2 SH2 domain binding peptides employing alpha-methylphenylalanyl based phosphotyrosyl mimetics

机译:使用基于α-甲基苯基丙氨酰基的磷酸酪氨酸模拟物设计和合成构象受限的Grb2 SH2结构域结合肽

获取原文
获取原文并翻译 | 示例
           

摘要

Previous work has shown that incorporation of either I-aminocyclohexanecarboxylic acid (Ac(6)c) or alpha-methyl-p-phosphonophenylalanine ((alpha-Me)Ppp) in the phosphotyrosyl (pTyr) C-proximal position (pY + 1 residue) of Grb2 SH2 domain binding peptides confers high affinity. The tetralin-based (S)-2-amino-6-phosphonotetralin-2-carboxylic acid (Atc(6-(POH2)-H-3)) simultaneously presents structural features of both (a-Me)Ppp and Ac(6)c residues. The current study compares the affinity of this tetralin hybrid Atc(6-PO3H2) versus Ac(6)c and (alpha-Me)Ppp residues when incorporated into the pY + I position of a high-affinity Grb2 SH2 domain binding tripeptide platform. The highest binding affinity (K-D = 14.8 nM) was exhibited by the (alpha-Me)Ppp-containing parent, with the corresponding Ac(6)c-containing peptide being nearly 2-fold less potent (K-D = 23.8 nM). The lower KD value was attributable primarily to a 50% increase in off-rate. Replacement of the Ac(6)c residue with the tetralin-based hybrid resulted in a further 4-fold decrease in binding affnity (K-D = 97.8 nM), which was the result of a further 6-fold increase in off-rate, offset by an approximate 45% increase in on-rate. Therefore, by incorporation of the key structural components found in (alpha-Me)Ppp into the Ac(6)c residue, the tetralin hybrid does enhance binding on-rate. However, net binding affinity is decreased due to an associated increase in binding off-rate. Alternatively, global conformational constraint of an ((alpha-Me)Ppp-containing peptide by beta-macrocyclization did result in pronounced elevation of binding affinity, which was achieved primarily through a decrease in the binding off-rate. Mathematical fitting using a simple model that assumed a single binding site yielded an effective KD of 2.28 nM. However this did not closely approximate the data obtained. Rather, use of a complex model that assumed two binding sites resulted in a very close fit of data and provided KD values of 97 pM and 72 nM for the separate sites, respectively. Therefore, although local conformational constraint in the pY + 1 residue proved to be deleterious, global conformational constraint through beta-macrocyclization achieved higher affinity. Similar beta-macrocyclization may potentially be extended to SH2 domain systems other than Grb2, where bend geometries are required.
机译:以前的工作表明,I-氨基环己烷羧酸(Ac(6)c)或α-甲基-对-膦酰基苯丙氨酸((alpha-Me)Ppp)在磷酸酪氨酰(pTyr)C-近端位置(pY + 1残基)掺入Grb2 SH2结构域结合肽的)赋予高亲和力。基于四氢萘的(S)-2-氨基-6-膦四氢-2-羧酸(Atc(6-(POH2)-H-3))同时呈现(a-Me)Ppp和Ac(6 )c残留物。当前的研究比较了掺入高亲和力的Grb2 SH2域结合三肽平台的pY + I位置时,这种四氢萘杂化Atc(6-PO3H2)与Ac(6)c和(alpha-Me)Ppp残基的亲和力。最高的结合亲和力(K-D = 14.8 nM)由含(alpha-Me)Ppp的母体表现出来,相应的含Ac(6)c的肽的效价降低了近2倍(K-D = 23.8 nM)。较低的KD值主要是由于折价率提高了50%。 Ac(6)c残基替换为基于四氢萘的杂合体导致结合亲和力进一步降低4倍(KD = 97.8 nM),这是离解率,抵消水平进一步提高6倍的结果率提高了约45%。因此,通过将(alpha-Me)Ppp中发现的关键结构成分并入Ac(6)c残基,四氢萘杂化物确实会提高结合率。但是,净结合亲和力由于结合解离速率的相关增加而降低。或者,通过(β-大环化)对((alpha-Me)Ppp的肽的整体构象约束确实导致了结合亲和力的显着提高,这主要是通过降低结合解离速率来实现的。假设单个结合位点产生的有效KD为2.28 nM,但这并不能非常接近所获得的数据,而是使用假设两个结合位点的复杂模型,得到的数据非常接近,KD值为97 pM和72 nM分别位于单独的位点,因此,尽管pY +1残基中的局部构象约束被证明是有害的,但通过β-大环化的整体构象约束获得了更高的亲和力,类似的β-大环化可能会扩展到SH2域除了需要弯曲几何形状的Grb2以外的其他系统。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号