...
首页> 外文期刊>Journal of Geophysical Research. Biogeosciences >SENSITIVITY OF DIRECT CLIMATE FORCING BY ATMOSPHERIC AEROSOLS TO AEROSOL SIZE AND COMPOSITION
【24h】

SENSITIVITY OF DIRECT CLIMATE FORCING BY ATMOSPHERIC AEROSOLS TO AEROSOL SIZE AND COMPOSITION

机译:大气气溶胶直接对气候强迫对气溶胶粒径和组成的敏感性

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

We evaluate, using a box model, the sensitivity of direct climate forcing by atmospheric aerosols for a ''global mean'' aerosol that consists of fine and coarse modes to aerosol composition, aerosol size distribution, relative humidity (RH), aerosol mixing state (internal versus external mixture), deliquescence/crystallization hysteresis, and solar zenith angle. We also examine the dependence of aerosol upscatter fraction on aerosol size, solar zenith angle, and wavelength and the dependence of single scatter albedo on wavelength and aerosol composition. The single most important parameter in determining direct aerosol forcing is relative humidity, and the most important process is the increase of the aerosol mass as a result of water uptake. An increase of the relative humidity from 40 to 80% is estimated for the global mean aerosol considered to result in an increase of the radiative forcing by a factor of 2.1. Forcing is relatively insensitive to the fine mode diameter increase due to hygroscopic growth, as long as this mode remains inside the efficient scattering size region. The hysteresis/deliquescence region introduces additional uncertainty but, in general, errors less than 20% result by the use of the average of the two curves to predict forcing. For fine aerosol mode mean diameters in the 0.2-0.5 mu m range direct aerosol forcing is relatively insensitive (errors less than 20%) to variations of the mean diameter. Estimation of the coarse mode diameter within a factor of 2 is generally Sufficient for the estimation of the total aerosol radiative forcing within 20%. Moreover, the coarse mode, which represents the nonanthropogenic fraction of the aerosol, is estimated to contribute less than 10% of the total radiative forcing for all RHs of interest. Aerosol chemical composition is important to direct radiative forcing as it determines (1) water uptake with RH, and (2) optical properties. The effect of absorption by aerosol components on forcing is found to be significant even for single Scatter albedo values of omega=0.93-0.97. The absorbing aerosol component reduces the aerosol forcing from that in its absence by roughly 30% at 60% RH and 20% at 90% RH. The mixing state of the aerosol (internal versus external) for the particular aerosol considered here is found to be of secondary importance, While sulfate mass scattering efficiency (m(2) (g SO42-)(-1)) and the normalized sulfate forcing(W (g SO42-)(-1))increase strongly with RH, total mass scattering efficiency (m(2) g(-1))and normalized forcing (W g(-1)) are relatively insensitive to RH, wherein the mass of all species, including water, are accounted for. Following S. Nemesure et al. (Direct shortwave forcing of climate by;anthropogenic sulfate aerosol: sensitivity to particle size, composition, and relative humidity, submitted to Journal of Geophysical Research, 1995), we find that aerosol forcing achieves a maximum at a particular solar zenith angle, reflecting a balance between increasing upscatter fraction with increasing solar zenith angle and decreasing solar flux (from Rayleigh scattering) with increasing solar zenith angle. [References: 71]
机译:我们使用盒模型评估大气气溶胶对“全球平均”气溶胶直接强迫气候的敏感性,该气溶胶由精细和粗糙模式组成,包括气溶胶成分,气溶胶尺寸分布,相对湿度(RH),气溶胶混合状态(内部与外部混合物),潮解/结晶滞后和太阳天顶角。我们还检查了气溶胶上散射分数对气溶胶尺寸,太阳天顶角和波长的依赖性以及单散射反照率对波长和气溶胶成分的依赖性。确定直接气溶胶强迫的最重要的参数是相对湿度,最重要的过程是由于吸水而导致的气溶胶质量增加。据估计,全球平均气溶胶的相对湿度从40%增至80%,这被认为会导致辐射强迫增加2.1倍。只要由于该模式保持在有效散射尺寸区域内,强迫对由于吸湿性增长引起的精细模式直径增大就相对不敏感。磁滞/潮解区引入了额外的不确定性,但通常,使用两条曲线的平均值来预测强迫会导致小于20%的误差。对于精细的气溶胶模式,平均直径在0.2-0.5微米范围内,直接气溶胶强迫对平均直径的变化相对不敏感(误差小于20%)。通常,粗模式直径的估计值在2倍以内,足以估计总气溶胶辐射强迫在20%以内。此外,粗模式代表了气溶胶的非人为因素,估计对所有感兴趣的RH贡献不到总辐射强迫的10%。气溶胶的化学成分对于指导辐射强迫很重要,因为它决定了(1)RH的吸水率和(2)光学性能。发现即使对于omega = 0.93-0.97的单个Scatter反照率值,气溶胶成分的吸收对强迫的影响也很显着。相对于不存在的情况,吸收性气溶胶成分将其不存在时的气溶胶强迫在60%RH下降低了约30%,在90%RH下降低了20%。发现此处考虑的特定气溶胶的气溶胶混合状态(内部与外部)是次要的,而硫酸盐的质量散射效率(m(2)(g SO42-)(-1))和归一化的硫酸盐强迫(W(g SO42-)(-1))随RH急剧增加,总质量散射效率(m(2)g(-1))和归一化强迫(W g(-1))对RH相对不敏感,其中包括水在内的所有物种的质量均占在内。继S. Nemesure等。 (人为产生的硫酸盐气溶胶对气候的直接短波强迫:对粒径,组成和相对湿度的敏感性,已提交给《地球物理研究杂志》,1995年),我们发现气溶胶强迫在特定的太阳天顶角处达到最大值,反映了随太阳天顶角增加而增加的向上散射分数与随着太阳天顶角增加而减少的太阳通量(来自瑞利散射)之间的平衡。 [参考:71]

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号