...
首页> 外文期刊>Journal of Geophysical Research. Biogeosciences >Inference of tidal elevation in shallow water using a vessel-towed acoustic Doppler current profiler
【24h】

Inference of tidal elevation in shallow water using a vessel-towed acoustic Doppler current profiler

机译:使用船只拖曳声多普勒电流剖面仪推断浅水区的潮汐高度

获取原文
获取原文并翻译 | 示例

摘要

Vessel-towed acoustic Doppler current profilers (ADCPs) have been widely used to measure velocity profiles. Since the instrument is usually mounted on a catamaran floating on the surface, previous studies have used the water surface as the reference level from which the vertical coordinate for the velocity profile is defined. However, because of the tidal oscillation, the vertical coordinate thus defined is time-dependent in an Earth-coordinate system, which introduces an error to the estimated harmonic constants for the velocity. As a result, the total transport will also be in error. This is particularly a problem in shallow waters where the tidal elevation is relatively large. Therefore tidal elevation needs to be resolved to make a correct harmonic analysis for the velocity. The present study is aimed at resolving the tidal elevation change in shallow water using a vessel-towed ADCP. Semidiurnal and diurnal tidal elevations across the lower Chesapeake Bay have been determined using a vessel-towed ADCP. Data from four cruises ranging from 25 to 92 hours in 1996 and 1997 are used. Water depth averaged every 30 s by the ADCP is studied by harmonic and statistical analysis. By selecting only the data within a narrow band (similar to 320 m) over the planned transect, we are able to improve the reliability of the data. We then grid the depth data along the 16 km transect into 200 equal segments and use harmonic analysis to resolve the semidiurnal and diurnal tidal variations within each segment. We find that (1) the depth data from the ADCP contain both semidiurnal and diurnal signals that can be resolved, from which the surface elevation can be inferred, (2) the major error appears to come from spatial variation of the depth, (3) the semidiurnal and diurnal tidal variations of elevation inferred over Aat bottom topography account for almost 100% of the total variability, while those measurements over large bottom slopes account for a much lower percentage of the total variability, (4) at least 70% of the variability of depth can be explained by semidiurnal and diurnal tides if the bottom slope is smaller than 0.006, and (5) the spatial variation of both amplitude and phase of the elevation along the transect appears to be small with a slightly lower tidal amplitude at the south of the Chesapeake Bay entrance, consistent with the Coriolis effect. The inferred elevations from the ADCP readings are consistent with sea level measurements at a tide station 10 km inside the estuary. [References: 10]
机译:拖船声多普勒电流剖面仪(ADCP)已被广泛用于测量速度剖面。由于该仪器通常安装在浮在水面上的双体船上,因此以前的研究已将水面用作参考水位,从中定义了速度剖面的垂直坐标。然而,由于潮汐振荡,因此在地球坐标系中这样定义的垂直坐标是时间相关的,这将误差引入了估计的速度谐波常数。结果,总运输也将是错误的。这在潮汐高度相对较大的浅水中尤其是一个问题。因此,需要解决潮汐高度问题,以便对速度进行正确的谐波分析。本研究旨在解决使用船拖式ADCP解决浅水区潮汐变化的问题。使用船只拖曳式ADCP确定了切萨皮克湾下游的半日潮汐和日潮汐。使用了1996年和1997年从25到92小时的四次航行的数据。通过谐波分析和统计分析研究ADCP平均每30秒的水深。通过仅选择计划样带的窄带(类似于320 m)内的数据,我们能够提高数据的可靠性。然后,我们将沿16 km断面的深度数据网格划分为200个相等的线段,并使用谐波分析来解决每个线段内的半日和日潮汐变化。我们发现(1)来自ADCP的深度数据包含可以解析的半日和日信号,从中可以推断出表面高度;(2)主要误差似乎来自深度的空间变化,(3 )在Aat底部地形上推断出的半日和昼间潮汐变化几乎占总变异性的100%,而在大底部坡度上进行的测量则占总变异性的百分比要低得多,(4)至少占70%如果底部坡度小于0.006,则深度的变化可以用半日潮和日潮来解释,并且(5)沿样条线的高程振幅和相位的空间变化似乎很小,潮汐振幅在切萨皮克湾入口以南,与科里奥利效应一致。 ADCP读数推断出的海拔高度与河口内10 km的潮汐站的海平面测量值一致。 [参考:10]

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号