...
首页> 外文期刊>Diffusion and Defect Data. Solid State Data, Part B. Solid State Phenomena >Applications of Nanostructured Materials as Gas Sensors
【24h】

Applications of Nanostructured Materials as Gas Sensors

机译:纳米结构材料作为气体传感器的应用

获取原文
获取原文并翻译 | 示例
           

摘要

Gas detection instruments are increasingly needed for industrial health and safety, environmental monitoring, and process control. To meet this demand, considerable research into new sensors is underway, including efforts to enhance the performance of traditional devices, such as resistive metal oxide sensors, through nanoengineering. The resistance of semiconductors is affected by the gaseous ambient. The semiconducting metal oxides based gas sensors exploit this phenomenon. Physical chemistry of solid metal surfaces plays a dominant role in controlling the gas sensing characteristics. Metal oxide sensors have been utilized for several decades for low-cost detection of combustible and toxic gases. Recent advances in nanomaterials provide the opportunity to dramatically increase the response of these materials, as their performance is directly related to exposed surface volume. Proper control of grain size remains a key challenge for high sensor performance. Nanoparticles of SnO_2 have been synthesized through chemical route at 5, 25 and 50oC. The synthesized particles were sintered at 400, 600 and 800oC and their structural and morphological analysis was carried out using X-ray diffraction (XRD) and transmission electron microscopy (TEM). The reaction temperature is found to be playing a critical role in controlling nanostructure sizes as well as agglomeration. It has been observed that particle synthesized at 5 and 50oC are smaller and less agglomerated as compared to the particles prepared at 25oC. The studies revealed that particle size and agglomeration increases with increase in sintering temperature. Thick films gas sensors were fabricated using synthesized tin dioxide powder and sensing response of all the sensors to ethanol vapors was investigated at different temperatures and concentrations. The investigations revealed that sensing response of SnO_2 nanoparticles is size dependent and smaller particles display higher sensitivity. Table of Contents
机译:气体检测仪器越来越需要用于工业健康和安全,环境监测以及过程控制。为了满足这种需求,正在进行对新型传感器的大量研究,包括努力通过纳米工程来提高诸如电阻式金属氧化物传感器之类的传统设备的性能。半导体的电阻受气体环境的影响。基于半导体金属氧化物的气体传感器利用了这种现象。固体金属表面的物理化学在控制气体传感特性方面起着主要作用。金属氧化物传感器已经被用于低成本可燃气体和有毒气体的检测。纳米材料的最新进展为大幅提高这些材料的响应提供了机会,因为它们的性能与暴露的表面体积直接相关。正确控制晶粒尺寸仍然是实现高传感器性能的关键挑战。 SnO_2的纳米粒子已经通过化学途径在5、25和50oC下合成。将合成的颗粒在400、600和800oC下烧结,并使用X射线衍射(XRD)和透射电子显微镜(TEM)对其结构和形态进行分析。发现反应温度在控制纳米结构尺寸以及团聚中起关键作用。已经观察到,与在25oC制备的颗粒相比,在5和50oC合成的颗粒更小且更少团聚。研究表明,随着烧结温度的升高,粒径和团聚度也随之增加。使用合成的二氧化锡粉末制造了厚膜气体传感器,并研究了在不同温度和浓度下所有传感器对乙醇蒸气的传感响应。研究表明,SnO_2纳米颗粒的传感响应与尺寸有关,较小的颗粒显示较高的灵敏度。目录

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号