Comparison of the Breakthrough Curves obtained by ASTM D2007-03annex 1 and on a Bench Unit for the Selection of Adsorbents for theRemoval of Nitrogen and Sulfur Contaminants from Fuels

摘要

The use of adsorbents in the final steps during petroleum fuels refining is still the usual practice in Brazilian refineries. The production of kerosene via the Bender process still demands that the fuel goes through a bed of clay to remove nitrogen contaminants. Thus, several studies are being developed based on adsorption over clays for the removal of nitrogen and sulfur compounds. However, the major problem is the sharp decrease in the adsorbents durability. The procedure currently employed by the refineries is the one recommended by the annex 1 from ASTM D2007 methodology. By this method, the evaluation of the adsorbent capacity is done without any pretreatment for water removal. This study aimed to establish a comparison between the results obtained by ASTM D2007 with the results obtained by a procedure developed on a bench unit which comprises a pretreating stage to remove water from the adsorbents before feeding the column. The results show that the water content strongly influences the adsorption capacity of the clays, and may even spoil high-capacity adsorbents if they are not pretreated for water removal.