首页> 外文期刊>Journal of chromatography, A: Including electrophoresis and other separation methods >Development of a solid-phase microextraction method for the analysis of phenolic flame retardants in water samples
【24h】

Development of a solid-phase microextraction method for the analysis of phenolic flame retardants in water samples

机译:固相微萃取方法用于水样中酚类阻燃剂分析的开发

获取原文
获取原文并翻译 | 示例
           

摘要

A solid-phase microextraction (SPME) method for the ultra-trace determination of brominated phenols in aqueous samples has been developed and is reported for the first time to the best of our knowledge. 3,5,3',5'-tetrabromobisphenol A (TBBPA), the most widely used brominated flame retardant, and other phenolic flame retardants in commercial use, such as 2,4-dibromophenol (2,4-DBP), 2,4,6-tribromophenol (TBP) and pentabromophenol (PBP) have been included as target analytes. The analytical procedure involves the in situ acetylation-SPME and gas chromatography-mass spectrometry (GC-MS) determination of the target analytes. A multi-factor categorical experimental design was created to study the main parameters affecting the extraction efficiency, allowing also the evaluation of interaction effects between factors. The factors studied were type of fiber, extraction mode, exposing the fiber directly into the sample (DSPME) or into the headspace over the sample (HSSPME), and extraction temperature. Carboxen-polydimethylsiloxane (CAR-PDMS) fiber appeared to be the most suitable of the five fibers tested for the extraction of most compounds, excluding PBP and TBBPA for which polydimethylsiloxane (PDMS) was the most efficient coating. The highest response was achieved for both fibers sampling in headspace mode at 100 degrees C. In order to test the linearity of the method, calibration studies were performed with both CAR-PDMS and PDMS coatings. For both fibers, the method was linear in a range of 2 orders of magnitude, giving relative standard deviation (RSD%) below 10% for most compounds and detection limp its at the low pg/mL level. In addition, the feasibility of the method for simultaneous determination of chlorinated and brominated phenols was studied. Finally, the method was applied to several real samples including tap water and effluent and influent waste water samples from an urban treatment plant. in which several phenolic compounds, such as phenol, methylphenols and chlorophenols, could be detected and quantified. (c) 2006 Elsevier B.V. All fights reserved.
机译:已开发出一种用于痕量测定水溶液样品中溴酚的超痕量固相微萃取(SPME)方法,据我们所知,这是首次报道。 3,5,3',5'-四溴双酚A(TBBPA),最广泛使用的溴化阻燃剂,以及其他商业上使用的酚类阻燃剂,例如2,4-二溴苯酚(2,4-DBP),2, 4,6-三溴苯酚(TBP)和五溴苯酚(PBP)已包括在内作为目标分析物。分析程序涉及目标分析物的原位乙酰化-SPME和气相色谱-质谱(GC-MS)测定。建立了多因素分类实验设计,以研究影响提取效率的主要参数,还可以评估因素之间的相互作用。研究的因素包括纤维的类型,提取方式,将纤维直接暴露于样品(DSPME)或样品上方的顶空(HSSPME)以及提取温度。羧甲基-聚二甲基硅氧烷(CAR-PDMS)纤维似乎是最适合萃取大多数化合物的五种纤维,其中PBP和TBBPA除外,其中聚二甲基硅氧烷(PDMS)是最有效的涂层。在100°C的顶空模式下,两种纤维采样均获得了最高响应。为了测试该方法的线性,对CAR-PDMS和PDMS涂层均进行了校准研究。对于这两种纤维,该方法在2个数量级的范围内都是线性的,大多数化合物的相对标准偏差(RSD%)低于10%,并且检测法在低pg / mL的水平上表现出mp脚。此外,研究了同时测定氯代和溴代酚的方法的可行性。最后,该方法被应用于几个真实的样本,包括自来水以及城市污水处理厂的污水和进水废水样本。其中可以检测和定量几种酚类化合物,例如苯酚,甲基苯酚和氯酚。 (c)2006年Elsevier B.V.版权所有。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号