首页> 外文期刊>Journal of Catalysis >Ni/SiO2 catalyst effective for methane decomposition into hydrogen and carbon nanofiber
【24h】

Ni/SiO2 catalyst effective for methane decomposition into hydrogen and carbon nanofiber

机译:Ni / SiO2催化剂可有效将甲烷分解为氢和碳纳米纤维

获取原文
获取原文并翻译 | 示例
获取外文期刊封面目录资料

摘要

Methane decomposition into hydrogen and carbon nanofibers was carried out over Ni/SiO2. The catalytic activity of Ni/SiO2 decreased with time on stream and finally the catalyst was deactivated completely. The initial catalytic activity and the yields of hydrogen and carbon nanofibers until complete deactivation of the catalysts depended strongly on the loading amount of Ni. The yield of carbon nanofibers reached the maximum (491 g(C)/g(Ni)) for Ni (40 wt%)/SiO2, which is one of the highest values among those for catalysts reported so far. SEM images of the catalysts after methane decomposition suggested that the particle size of Ni metal controlled the yields of hydrogen and carbon nanofibers. The yields of hydrogen and carbon nanofibers also depended significantly on the reaction temperatures; i.e., the yields decreased sharply with a rise in the reaction temperatures at > 773 K. In addition, the reaction temperatures controlled the diameter and graphitic order of carbon nanofibers. (C) 2003 Elsevier Science (USA). All rights reserved. [References: 30]
机译:在Ni / SiO2上甲烷分解为氢和碳纳米纤维。 Ni / SiO2的催化活性随生产时间的延长而降低,最终使催化剂完全失活。直到催化剂完全失活之前,初始的催化活性以及氢和碳纳米纤维的产率在很大程度上取决于Ni的负载量。碳纳米纤维的收率达到Ni(40 wt%)/ SiO2的最大值(491 g(C)/ g(Ni)),这是迄今为止报道的催化剂中最高的值之一。甲烷分解后催化剂的SEM图像表明,镍金属的粒径控制着氢和碳纳米纤维的产率。氢和碳纳米纤维的产率也明显取决于反应温度。即,随着> 773K的反应温度的升高,产率急剧下降。另外,反应温度控制了碳纳米纤维的直径和石墨顺序。 (C)2003 Elsevier Science(美国)。版权所有。 [参考:30]

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号