首页> 外文期刊>Journal of biomedical materials research. Part B, Applied biomaterials. >Effect of titanium surface roughness on proliferation, differentiation, and protein synthesis of human osteoblast-like cells (MG63).
【24h】

Effect of titanium surface roughness on proliferation, differentiation, and protein synthesis of human osteoblast-like cells (MG63).

机译:钛表面粗糙度对人成骨样细胞(MG63)增殖,分化和蛋白质合成的影响。

获取原文
获取原文并翻译 | 示例
           

摘要

The effect of surface roughness on osteoblast proliferation, differentiation, and protein synthesis was examined. Human osteoblast-like cells (MG63) were cultured on titanium (Ti) disks that had been prepared by one of five different treatment regimens. All disks were pretreated with hydrofluroic acid-nitric acid and washed (PT). PT disks were also: washed, and then electropolished (EP); fine sandblasted, etched with HCl and H2SO4, and washed (FA); coarse sandblasted, etched with HCl and H2SO4, and washed (CA); or Ti plasma-sprayed (TPS). Standard tissue culture plastic was used as a control. Surface topography and profile were evaluated by brightfield and darkfield microscopy, cold field emission scanning electron microscopy, and laser confocal microscopy, while chemical composition was mapped using energy dispersion X-ray analysis and elemental distribution determined using Auger electron spectroscopy. The effect of surface roughness on the cells was evaluated by measuring cell number, [3H]thymidine incorporation into DNA, alkaline phosphatase specific activity, [3H]uridine incorporation into RNA, [3H]proline incorporation into collagenase digestible protein (CDP) and noncollagenase-digestible protein (NCP), and [35S]sulfate incorporation into proteoglycan. Based on surface analysis, the five different Ti surfaces were ranked in order of smoothest to roughest: EP, PT, FA, CA, and TPS. A TiO2 layer was found on all surfaces that ranged in thickness from 100 A in the smoothest group to 300 A in the roughest. When compared to confluent cultures of cells on plastic, the number of cells was reduced on the TPS surfaces and increased on the EP surfaces, while the number of cells on the other surfaces was equivalent to plastic. [3H]Thymidine incorporation was inversely related to surface roughness. Alkaline phosphatase specific activity in isolated cells was found to decrease with increasing surface roughness, except for those cells cultured on CA. In contrast, enzyme activity in the cell layer was only decreased in cultures grown on FA- and TPS-treated surfaces. A direct correlation between surface roughness and RNA and CDP production was found. Surface roughness had no apparent effect on NCP production. Proteoglycan synthesis by the cells was inhibited on all the surfaces studied, with the largest inhibition observed in the CA and EP groups. These results demonstrate that surface roughness alters osteoblast proliferation, differentiation, and matrix production in vitro. The results also suggest that implant surface roughness may play a role in determining phenotypic expression of cells in vivo.
机译:检查了表面粗糙度对成骨细胞增殖,分化和蛋白质合成的影响。将人类成骨样细胞(MG63)培养在通过五种不同治疗方案之一制备的钛(Ti)盘上。将所有圆盘用氢氟酸-硝酸预处理并洗涤(PT)。还对PT盘进行了清洗:清洗,然后进行电抛光(EP);精细喷砂处理,用HCl和H2SO4蚀刻,然后洗涤(FA);粗喷砂,用HCl和H2SO4蚀刻,然后洗涤(CA);或钛等离子喷涂(TPS)。使用标准组织培养塑料作为对照。通过明场和暗场显微镜,冷场发射扫描电子显微镜和激光共聚焦显微镜评估表面形貌和轮廓,同时使用能量色散X射线分析法绘制化学成分图,并使用俄歇电子能谱法确定元素分布。通过测量细胞数量,[3H]胸苷掺入DNA,碱性磷酸酶比活性,[3H]尿苷掺入RNA,[3H]脯氨酸掺入胶原酶可消化蛋白(CDP)和非胶原酶来评估表面粗糙度对细胞的影响。 -可消化蛋白质(NCP)和[35S]硫酸盐掺入蛋白聚糖。根据表面分析,将五个不同的Ti表面按从最光滑到最粗糙的顺序排序:EP,PT,FA,CA和TPS。在所有表面上发现了TiO2层,其厚度范围从最光滑的组中的100 A到最粗糙的组中的300A。与塑料上的细胞融合培养相比,TPS表面上的细胞数量减少了,而EP表面上的细胞数量增加了,而其他表面上的细胞数量与塑料相当。 [3H]胸苷的掺入与表面粗糙度成反比。发现在分离的细胞中碱性磷酸酶的比活性随表面粗糙度的增加而降低,除了在CA上培养的那些细胞。相反,仅在FA和TPS处理过的表面上生长的培养物中,细胞层中的酶活性才降低。发现表面粗糙度与RNA和CDP产量之间存在直接关系。表面粗糙度对NCP生产没有明显影响。细胞的蛋白聚糖合成在所有研究的表面上均受到抑制,在CA和EP组中观察到最大的抑制作用。这些结果证明表面粗糙度在体外改变成骨细胞的增殖,分化和基质产生。结果还表明,植入物表面粗糙度可能在确定体内细胞的表型表达中起作用。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号