...
首页> 外文期刊>Journal of Applied Crystallography >Precursors in stereo-complex crystals of poly(L-lactic acid)/poly(D-lactic acid) blends under shear flow
【24h】

Precursors in stereo-complex crystals of poly(L-lactic acid)/poly(D-lactic acid) blends under shear flow

机译:剪切流动下聚(L-乳酸)/聚(D-乳酸)共混物的立体复杂晶体中的前体

获取原文
获取原文并翻译 | 示例
           

摘要

To improve the mechanical and the thermal performance of poly(lactic acid) materials, this work focuses on the formation of stereo-complex crystals by blending poly(l-lactic acid) (PLLA) with poly(d-lactic acid) (PDLA). The resulting structure was analyzed using time-resolved in situ X-ray scattering, optical microscopy, differential scanning calorimetry and viscoelastic measurements. The objective of this study is to investigate the effect of shear flow imposed prior to crystallization on higher-order structure formation and acceleration of stereo-complex crystal growth of PLLA and PDLA blends using a wide spatial scale analysis and viscoelastic measurements. Density fluctuations of 100 nm scale were observed prior to nucleation by in situ simultaneous wideand small-angle X-ray scattering measurements. These density fluctuations grew with time and the intensity increased with increasing shear rate. Furthermore, the results revealed that the PLLA and PDLA chains were only partially interpenetrated; consequently, stereo-complex crystals could grow only in the mixed PLLA/PDLA phase. The correlation length of density fluctuation prior to nucleation was strongly dependent on the mixed phases.
机译:为了提高聚乳酸材料的机械性能和热性能,这项工作着重于通过将聚(l-乳酸)(PLLA)与聚(d-乳酸)(PDLA)混合形成立体复合晶体。 。使用时间分辨原位X射线散射,光学显微镜,差示扫描量热法和粘弹性测量对所得结构进行分析。这项研究的目的是使用广泛的空间尺度分析和粘弹性测量方法,研究结晶之前施加的剪切流对PLLA和PDLA共混物的高阶结构形成和立体复合晶体生长加速的影响。在成核之前,通过原位同时进行的广角和小角度X射线散射测量,观察到了100 nm标度的密度波动。这些密度波动随时间增加,强度随剪切速率增加而增加。此外,结果表明,PLLA和PDLA链仅部分互穿。因此,立体复合晶体只能在PLLA / PDLA混合相中生长。成核之前密度波动的相关长度在很大程度上取决于混合相。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号