Micro-copper powders recovered from waste printed circuit boards by electrolysis

摘要

The concentrated metal scraps, obtained by the mechanical process for waste printed circuit board (WPCB) recycling, were pressed as the anode, which was directly electrolyzed to produce copper powders. The effects of CuSO4 center dot 5H(2)O, NaCl and H2SO4 concentration, current density and electrolysis time on current efficiency and copper powder size were investigated in detail. The results indicated that current efficiency increased rapidly as the increase of CuSO(4 center dot)5H(2)O, H2SO4 concentration and current density. The obtained copper powders became finer with the increase of current density and NaCl concentration; and copper powders became coarser with the increase of CuSO4-5H(2)O concentration. Under the optimum conditions (50 g/L CuSO4 center dot 5H(2)O, 40 g/L NaCl, 118 g/L H2SO4, 80 mA/cm(2) for 3 h), current efficiency was the highest (98.12%) and the particle size was the finest (9.35 mu m). The experimental studies also revealed that the purity of copper obtained at the highest current efficiency was higher to 98.06%. Produced copper powders were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM) and transmission electron microscopy (TEM). XRD analysis indicated that copper was the main phase; SEM analysis showed that dendritic structure was the main characteristic of the obtained copper powders; 'TEM results indicated that at the end of the dendritic structure, the copper surface was coated with a layer of dense Cu2O. It is believed that the process is effective for copper recovery from concentrated WPCB metal scraps. (C) 2015 Elsevier B.V. All rights reserved.