Relations between spatial distribution and sequence types of the Cambrian-Ordovician marine source rocks in Tarim Basin

摘要

Marine source rocks are considered to be mainly composed of the Cambrian-Ordovician deposit in Tarim Basin. Based on the previous studies made by other researchers, the authors calculated the thickness and distribution scale of these Cambrian-Ordovician source rocks by integrating sequence stratigraphy with investigations on sedimentary environments, well-shooting demarcating and calibrating the thickness of unknown source rocks with the thickness of the known ones according to characteristics of thesource rocks that have "double track" seismic lineup reflectance. The results showed that the distribution area of the Lower-Cambrian Yuertusi Fm. source rock in platform inner depressions, slopes and deep basins is much bigger than that of the Middle Cambrian evaporite-lagoon source rock. Moreover, the former is superior to the latter in terms of the source rock quality. Likewise, the Middle-Ordovician Heituao Fm. source rock in the slopes and deep basins has a much wider distribution and better quality than the Upper Ordovician, and its quality is also better than those of the Shaergan and Yinggan Fms. source rock within platforms as well as the lime-mud-mound source rock along the fringe of the Upper-Ordovician platform. Most good Lower-Cambrian source rocks of the Kalpin outcrop lie on the initial ingression surface or in the condensed member of the Type I sequence. In this section, the source rock in Type II is inferior to that in Type I, even being far from an effective one (TOC: <0.5%). Likewise, the good Middle-Ordovician Heituao source rock also lies on the initial ingression surface or in the condensed member of the Type I sequence, while the poor Yinggan source rock and the lime-mud-mound along the fringe of the platform develop all in the Type II sequence. Under the condition of the same sea-level rising altitude and time, the ingression displacement (SO at the base border in Type I is larger than S_2 in Type II. Thus, the distribution of the source rock developed above the base borderin Type I is wider than that in Type II. The maximal ingression range dominates the ultimate distribution of source rocks. Because Si is greater than (S_1), the relative rate of ingression on the base border of Type I is obviously bigger than that of Type II. The difference in ingression rate is one of the factors that lead to the superiority of the source rock at the base border in Type I to that Type II. Therefore, it is of great significance to study the spatial distribution, developing era and quality determination of source rocks by means of sequence stratigrahpy.