...
首页> 外文期刊>The Veterinary Journal >A study of sub-occlusal secondary dentine thickness in overgrown equine cheek teeth.
【24h】

A study of sub-occlusal secondary dentine thickness in overgrown equine cheek teeth.

机译:马脸颊杂草丛生时牙合的第二牙本质厚度的研究。

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

The presence of cheek tooth loss or defects, with subsequent overgrowth of the opposing teeth, is common in horses. Little is known about the factors that control the deposition of sub-occlusal secondary dentine (SO2D) in normal equine teeth, but these are likely to include stimulation of the occlusal surface. There appears to be no information on the possible alterations to this process when teeth develop overgrowths and, consequently, of the net effect on SO2D thickness caused by reduced stimulation of the occlusal surface and of absent/reduced normal occlusal wear (attrition). Knowledge of the likely thickness of SO2D in overgrown teeth may help reduce the risks of pulp horn exposure or thermal damage during therapeutic reduction of overgrowths. This study utilised 24 permanent cheek teeth (CT) with overgrowths (mean overgrowth height: 9.5mm; range, 3.4-17.9mm), and 18 control CT obtained from 15 horses of different breeds and ages. The thickness of SO2D was measured above 94 matched pulp horns in control and overgrown CT and showed a mean value of 12.14mm (range 1.87-36.02mm) in overgrown teeth and of 10.25mm (range 2.64-17.26mm) in controls. There was no significant difference between SO2D thickness in overgrown (mean 11.38mm) and control (11.41mm) mandibular CT, but SO2D was significantly thicker in overgrown (mean 12.57mm) as compared to control maxillary (9.41mm) CT. A comparison of SO2D thickness above the 94 matched pulp horns in overgrown and control teeth showed that 49% (46/94) of pulps in overgrown teeth had less SO2D overlying them than had control teeth. Of major clinical relevance was that the height of dental overgrowths was greater than SO2D thickness over one or more pulp horns in 14/24 overgrown teeth. Consequently, reduction of these overgrown teeth to the level of adjacent normal-height teeth would cause occlusal pulp exposure in 58% of teeth, in addition to possible thermal damage to additional pulp horns. It was concluded that equine CT overgrowths should be gradually reduced, by a few millimetres at a time, over a prolonged period
机译:在马中,经常会出现面颊牙齿缺失或缺损,以及随后相对牙齿的过度生长。关于控制正常马齿中次颌次生牙本质(SO2D)沉积的因素知之甚少,但这些因素可能包括刺激牙合面。当牙齿发育过度生长时,似乎没有关于该过程可能发生变化的信息,因此,由于减少了对咬合面的刺激以及正常咬合磨损的减少/减少所导致的对SO2D厚度的净影响(磨损)。了解长满牙齿中可能存在的SO2D厚度可能有助于减少在治疗上减少过度生长时牙髓角暴露或热损伤的风险。这项研究使用了24个永久性颊齿(CT),其过度生长(平均过度生长高度:9.5mm;范围为3.4-17.9mm),以及从15个不同品种和年龄的马匹获得的18个对照CT。在对照和杂草丛生的CT中测量了94个匹配的牙髓角以上的SO2D厚度,在杂草丛生的牙齿中显示的平均值为12.14mm(范围1.87-36.02mm),在对照中显示为10.25mm(平均值为2.64-17.26mm)。在下颌CT长满(平均11.38mm)和对照(11.41mm)中,SO2D厚度之间没有显着差异,但在上颌长满CT(平均12.57mm)中,SO2D明显厚于对照(9.41mm)。比较长满牙齿和对照牙齿中94个匹配的牙髓上方的SO2D厚度,发现长满牙齿中49%(46/94)的牙髓上覆SO2D的量少于对照牙齿。主要临床相关性是在14/24长满的牙齿中,一个或多个牙髓上的牙齿过度生长的高度大于SO2D厚度。因此,将这些长满的牙齿减少到相邻的正常高度牙齿的水平会导致58%的牙齿咬合牙髓暴露,此外还会对其他牙髓产生热损伤。结论是,应长期延长马CT的过度生长,一次减少几毫米

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号