首页> 外文期刊>The Annals of occupational hygiene. >Personal exposure to inhalable dust and the specific latex Aero-Allergen, Hev b6.02, in latex glove manufacturing in Thailand
【24h】

Personal exposure to inhalable dust and the specific latex Aero-Allergen, Hev b6.02, in latex glove manufacturing in Thailand

机译:在泰国生产的乳胶手套中,个人接触可吸入的粉尘和特定的乳胶Aero-Allergen,HEV b6.02

获取原文
获取原文并翻译 | 示例
获取外文期刊封面目录资料

摘要

Objectives: Latex product manufacturing is an important industry in south-east Asia but has the potential for considerable occupational exposure of workers to latex allergens. Although exposure to latex allergens can result in adverse health reactions, few studies to characterize this exposure have been conducted to date. This study therefore aimed to characterize current airborne inhalable dust and the specific allergen, Hev b 6.02, exposures in this industry in Thailand. Methods: Workers were recruited from three factories in the southern part of Thailand. Full-shift inhalable dust personal air sampling was conducted using IOM sampling heads equipped with polytetrafluoroethylene filters at a 2.0 l min-1 flowrate. After weighing to determine inhalable dust levels, filters were extracted and analysed for Hev b 6.02 using an enzyme immunometric assay. Results: Two hundred and seventy-five workers agreed to participate, resulting in a total of 292 measurements. Geometric mean (GM) personal exposure to inhalable dust was 0.88mg m-3, but individual exposures up to 12.34mg m-3 were measured. The pattern of exposure was similar across factories, with highest exposures in the stripping (GM 2.08-4.05mg m-3 for the 3 factories) and tumbling departments (1.11-2.17mg m-3). Within-worker (day-to-day) variability contributed 92% to total variability. The Hev b 6.02 exposure pattern was similar with time-weighted average GM exposure levels in the oldest factory ranging from 8.7mg m-3 in the laboratory to 30.2mg m-3 in the stripping department. In contrast to inhalable dust exposure, total exposure variability was primary driven by variability between workers (67%). Conclusions: Workers in these latex product factories get routinely exposed to measurable Hev b 6.02 levels, which may give rise to increased incidence of allergic symptoms and occupational asthma. Also, in this measurement campaign a 10mg m-3, but not 15mg m-3, occupational exposure limit for inhalable dust was occasionally exceeded. Highest Hev b 6.02 exposures were found in the stripping and tumbling departments, which would be natural targets for interventions aimed at reducing exposure.
机译:目标:乳胶产品制造是东南亚的重要产业,但有可能使工人在乳胶过敏原中产生大量职业暴露。尽管接触乳胶过敏原会导致不良的健康反应,但迄今为止,很少有研究来表征这种接触。因此,本研究旨在表征泰国该行业当前的空气可吸入粉尘和特定过敏原Hev b 6.02。方法:从泰国南部的三个工厂招募工人。使用配备有聚四氟乙烯过滤器的IOM采样头以2.0 l min-1的流量进行全班可吸入粉尘个人空气采样。在称重以确定可吸入的粉尘水平后,提取过滤器并使用酶免疫测定法分析Hev b 6.02。结果:275名工人同意参加,总共进行了292次测量。个人暴露于可吸入粉尘的几何平均值(GM)为0.88mg m-3,但测得的个人暴露量最高为12.34mg m-3。各个工厂的暴露模式相似,在汽提(三个工厂的GM 2.08-4.05mg m-3)和翻滚部门(1.11-2.17mg m-3)中暴露量最高。员工内部(日常)变异性占总变异性的92%。 Hev b 6.02暴露模式与最老工厂中时间加权平均GM暴露水平相似,范围从实验室的8.7mg m-3到剥离部门的30.2mg m-3。与可吸入粉尘暴露相比,总暴露差异主要由工人之间的差异(67%)驱动。结论:这些乳胶制品工厂的工人经常暴露于可测的Hev b 6.02水平,这可能导致过敏症状和职业性哮喘的发生率增加。另外,在该测量活动中,偶尔会超过10mg m-3,但未超过15mg m-3的可吸入粉尘职业接触限值。在剥离和翻滚部门中发现最高的Hev b 6.02暴露,这将是旨在减少暴露的干预措施的自然目标。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号