首页> 外文期刊>Progress in photovoltaics >Pushing the limits of concentrated photovoltaic solar cell tunnel junctions in novel high-efficiency GaAs phototransducers based on a vertical epitaxial heterostructure architecture
【24h】

Pushing the limits of concentrated photovoltaic solar cell tunnel junctions in novel high-efficiency GaAs phototransducers based on a vertical epitaxial heterostructure architecture

机译:基于垂直外延异质结构架构的新型高效GaAs光电换能器突破了集中光伏太阳能电池隧道结的极限

获取原文
获取原文并翻译 | 示例
           

摘要

A monolithic compound semiconductor phototransducer optimized for narrow-band light sources was designed for achieving conversion efficiencies exceeding 50%. The III-V heterostructure was grown by metal-organic chemical vapor deposition, based on the vertical stacking of 5 partially absorbing GaAs n/p junctions connected in series with tunnel junctions. The thicknesses of the p-type base layers of the diodes were engineered for optimal absorption and current matching for an optical input with wavelengths centered near 830 nm. Devices with active areas of similar to 3.4 mm(2) were fabricated and tested with different emitter gridline spacings. The open circuit voltage (Voc) of the electrical output is five times or more than that of a single GaAs n/p junction under similar illumination. The device architecture allows for improved Voc generation in the individual base segments because of efficient carrier extraction while simultaneously maintaining a complete absorption of the input photons with no needs for complicated fabrication processes or reflecting layers. With illumination powers in the range of a few 100 mW, the measured fill factor (FF) varied between 88 and 89%, and the Voc reached over 5.75 V. The data also demonstrated that a proper combination of highly doped emitter and window layers without gridlines is adequate for sustaining such FF values for optical input powers of several hundred milliwatts. As the optical input power is further increased and approaches 2W (intensities similar to 58 W/cm(2)), the multiple tunnel junctions sequentially exceed their peak current densities in the case for which typical (n++) GaInP/(p++) AlGaAs concentrated photovoltaic tunnel junctions are used. Lower bandgap tunnel junctions designed with improved peak current densities result in phototransducer devices having high FF and conversion efficiencies for up to 5W optical input powers (intensities similar to 144 W/cm(2)). Measurements at different temperatures revealed a Voc reduction of -6 mV/degrees C at similar to 59W/cm(2). Copyright (C) 2015 John Wiley & Sons, Ltd.
机译:设计了一种针对窄带光源优化的单片化合物半导体光电换能器,以实现超过50%的转换效率。通过垂直堆叠5个与隧道结串联连接的5部分吸收GaAs n / p结,可以通过金属有机化学气相沉积法生长III-V异质结构。对二极管的p型基极层的厚度进行了设计,以实现波长在830 nm附近的光输入的最佳吸收和电流匹配。制作了具有类似于3.4 mm(2)的有效面积的设备,并使用了不同的发射极网格线间距进行了测试。在相似的照明下,电输出的开路电压(Voc)是单个GaAs n / p结的开路电压(Voc)的五倍或更多。由于有效的载流子提取,器件结构允许在各个基本段中改善Voc的产生,同时保持输入光子的完全吸收,而无需复杂的制造过程或反射层。当照明功率在几百mW的范围内时,测得的填充系数(FF)在88%至89%之间变化,并且Voc达到5.75 V以上。数据还表明,高掺杂发射极和窗口层的适当组合没有网格线足以维持数百毫瓦的光输入功率的FF值。随着光输入功率的进一步增加并接近2W(强度类似于58 W / cm(2)),在典型(n ++)GaInP /(p ++)AlGaAs集中的情况下,多个隧道结依次超过其峰值电流密度。使用光伏隧道结。具有改进的峰值电流密度的较低带隙隧道结设计使光电换能器器件具有高FF和高达5W的光输入功率(强度类似于144 W / cm(2))的转换效率。在不同温度下的测量结果表明,与59W / cm(2)相似,VOC降低了-6 mV /℃。版权所有(C)2015 John Wiley&Sons,Ltd.

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号