首页> 外文期刊>Powder Technology: An International Journal on the Science and Technology of Wet and Dry Particulate Systems >Preparation of a new ceramic microfiltration membrane from mineral coal fly ash: Application to the treatment of the textile dying effluents
【24h】

Preparation of a new ceramic microfiltration membrane from mineral coal fly ash: Application to the treatment of the textile dying effluents

机译:用矿物粉煤灰制备新型陶瓷微滤膜:在处理印染废水中的应用

获取原文
获取原文并翻译 | 示例
           

摘要

New microfiltration membranes from mineral coal fly-ash material are obtained using ceramic method. Paste from mineral coal fly ash (obtained by calcinations at 800 °C of non-grinded mineral coal) is extruded to elaborate a porous tubular configuration used as supports.The support heated at 1125 °C, shows an average pore diameter and porosity of about 4.5 μm and 51%, respectively. The properties in terms of mechanical and corrosion resistances are very interesting. The elaboration of the layer based on fly-ash powder (obtained by sintering at 700 °C of a finely grinded mineral coal) is performed by slip-casting method. The heating treatment at 800 °C leads to an average pore size of 0.25 μm. The water permeability determined of this membrane is 475 L/h m~2 bar. This membrane can be used for crossflow microfiltration. The application to the treatment of the dying effluents generated by the washing baths in the textile industry shows an important decrease of turbidity (inferior to 1 NTU), of chemical oxygen demand (COD) values (retention rate of about 75%) and a total color removal. The performances in term of permeate flux and efficiency were determined and compared to those obtained using a commercial alumina microfiltration membrane. Almost the same stabilised permeate flux was obtained (about 100 L h~(-1) m~(-2)). So, it seems that the prepared membrane is suitable for such wastewater treatment.
机译:采用陶瓷法从矿物粉煤灰材料中获得了新的微滤膜。将矿物粉煤灰的糊状物(通过在800°C的温度下煅烧获得的未磨碎的矿物煤)挤出,制成用于支撑的多孔管状构型。加热到1125°C的载体的平均孔径和孔隙率约为分别为4.5μm和51%。机械和耐腐蚀性方面的特性非常有趣。基于粉煤灰粉末的层的精加工(通过在700°C下烧结细磨的矿物煤而获得)通过滑铸法进行。在800°C的热处理导致平均孔径为0.25μm。该膜的透水率确定为475 L / h m〜2 bar。该膜可用于错流微滤。在纺织工业中处理洗浴所产生的垂死废水的应用显示出浊度(低于1 NTU),化学需氧量(COD)值(保留率约75%)和总的显着降低。除色。确定渗透通量和效率方面的性能,并将其与使用商业氧化铝微滤膜获得的性能进行比较。获得了几乎相同的稳定渗透通量(约100 L h〜(-1)m〜(-2))。因此,似乎所制备的膜适合于这种废水处理。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号