...
首页> 外文期刊>Polymer engineering and science >Nanocomposite solid polymer electrolytes based on polyethylene oxide, modified nanoclay, and tetraethylammonium tetrafluoroborate for application in solid-state supercapacitor
【24h】

Nanocomposite solid polymer electrolytes based on polyethylene oxide, modified nanoclay, and tetraethylammonium tetrafluoroborate for application in solid-state supercapacitor

机译:基于聚环氧乙烷,改性的纳米粘土和四氟硼酸四乙铵的纳米复合固体聚合物电解质,用于固体超级电容器

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Nanocomposite solid polymer electrolytes (SPEs) have been prepared from polyethylene oxide (PEO), organically modified nanoclay (MNclay), and tetraethylammonium tetrafluoroborate (TEABF(4)) salt. The concentration of the salt has been varied in the respective SPE, wherein PEO/MNclay ratio was kept constant. It has been proposed that three types of complex formation could be operative in the SPEs due to the interactions among PEO, MNclay, and the salt. The complex formation mechanism has been postulated on the basis of X-ray diffraction (XRD) analysis, transmission electron microscopic (TEM) observation, differential scanning calorimetric (DSC) analysis, and polarized optical microscopic (POM) observation. Complex 1' and complex 3' formation could be involved in the crystalline phase as indicated by DSC and XRD analyses, whereas complex 2' formation might be restricted in the amorphous phase as suggested by TEM observation. The ionic conductivity of the SPEs has been correlated with the results obtained from XRD, DSC, and POM analyses. The formation of complex 1 and complex 2 could be responsible for the increase in the ionic conductivity, whereas complex 3 formation might decrease the ionic conductivity. An activated carbon-based supercapacitor has been fabricated using SPEs and characterized by cyclic voltammetry, galvanostatic charge-discharge' behavior, and impedance spectroscopic analysis. POLYM. ENG. SCI., 55:1536-1545, 2015. (c) 2015 Society of Plastics Engineers
机译:纳米复合固体聚合物电解质(SPE)已由聚环氧乙烷(PEO),有机改性的纳米粘土(MNclay)和四氟硼酸四乙铵(TEABF(4))盐制备。各个SPE中盐的浓度有所不同,其中PEO / MNclay比率保持恒定。由于PEO,MNclay和盐之间的相互作用,有人提出在SPE中可以使用三种类型的复合物形成。已经基于X射线衍射(XRD)分析,透射电子显微镜(TEM)观察,差示扫描量热法(DSC)分析和偏振光学显微镜(POM)观察来推测复合物形成机理。 DSC和XRD分析表明,络合物1'和络合物3'的形成可能与结晶相有关,而TEM观察表明,络合物2'的形成可能受限于非晶相。 SPE的离子电导率已与从XRD,DSC和POM分析获得的结果相关联。配合物1和配合物2的形成可能是导致离子电导率增加的原因,而配合物3的形成可能会降低离子电导率。活性炭基超级电容器已使用SPEs制成,并通过循环伏安法,恒电流充放电行为和阻抗谱分析进行了表征。 POLYM。 ENG。 SCI。,55:1536-1545,2015.(c)2015年塑料工程师学会

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号