...
首页> 外文期刊>Chemical science >Morphology, wettability and photomicropattereing of superhydrophoMc surface with high adhesive force by crystal growth of a photochromic iiarylethene
【24h】

Morphology, wettability and photomicropattereing of superhydrophoMc surface with high adhesive force by crystal growth of a photochromic iiarylethene

机译:通过光致变色二芳基乙烯的晶体生长,具有高粘附力的超疏水Mc表面的形貌,润湿性和光微图案化

获取原文
获取原文并翻译 | 示例
           

摘要

A photochromic diarylethene, 1,2-bis(2-methyl-6-nitro-1 -benzothiophen-3-yl)perfluorocyclopentene (1a), can undergo crystallization from the amorphous film in poly(methyl methacrylate) (PMMA) at 130 °C. The contact angle with water on the film changed from 82 to 132° upon crystallization. Moreover, by heating at 180 °C, the contact angle increased to 154°, showing a superhydrophobic surface (water contact angle >150°). The change in the contact angle can be ascribed to the surface roughness change by the crystal growth. The superhydrophobic surface also showed high-water adhesive properties. Patterning of the superhydrophobic and hydrophobic surfaces was performed using a photomask by photoirradiation leading to a resolution of about 10 μm. The contact angle on the photoirradiated area was reduced to 138° along with lowering of the surface roughness because of poorer crystal growth of the photoirradiated crystals. Such a superhydrophobic surface with high adhesive force is useful for water capturing devices.
机译:光致变色二芳基乙烯1,2-双(2-甲基-6-硝基-1-苯并噻吩-3-基)全氟环戊烯(1a)可以在130°C下从聚甲基丙烯酸甲酯(PMMA)中的非晶膜中结晶出来C。结晶时,膜上与水的接触角从82°变为132°。此外,通过在180℃下加热,接触角增加至154°,显示出超疏水表面(水接触角> 150°)。接触角的变化可以归因于晶体生长引起的表面粗糙度变化。超疏水表面还显示出高水粘合性能。使用光掩模通过光照射对超疏水性和疏水性表面进行图案化,从而产生约10μm的分辨率。由于光照射的晶体的较差的晶体生长,随着表面粗糙度的降低,在光照射的区域上的接触角减小到138°。这种具有高粘合力的超疏水表面可用于集水装置。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号