...
首页> 外文期刊>Chemical Engineering Science >Study of geometry and operational conditions on mixing time, gas hold up, mass transfer, flow regime and biomass production from natural gas in a horizontal tubular loop bioreactor
【24h】

Study of geometry and operational conditions on mixing time, gas hold up, mass transfer, flow regime and biomass production from natural gas in a horizontal tubular loop bioreactor

机译:在卧式管状回路生物反应器中研究混合时间,气体滞留,传质,流态和天然气生物质生产的几何形状和操作条件

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

A horizontal tubular loop bioreactor (HTLB) was used for production of biomass from natural gas. Hydrodynamic characterizations (mixing time and gas hold up) and mass transfer coefficients were considered in the HTLB (L = 2.2 m, H = 0.4 in and D = 0.03 m) as functions of design parameters, i.e., horizontal length to diameter ratio (L/D) and volume of gas-liquid separator (S) as well as operational parameters, i.e., superficial gas and liquid velocities (U-sG, U-sL) In addition, flow regime in different gas and liquid flow rates was investigated. It was observed from experimental results that U-sL has remarkable effects on gas hold up and k(L)a due to its influence on mixing time. The volumetric mass transfer coefficients for oxygen (k(L)a(O2)) and methane (k(L)a(CH4)) were determined at different geometrical and operational factors. In average, the amount of oxygen consumption for metabolism is approximately 1.4 times higher than that of methane. In bubble flow regime, the HTLB was used for biomass production, too. A gas mixture of 50% methane and 50% oxygen (based on results of dry cell weight, optical density and doubling time) was the best gas mixture inlet for biomass production. The empirical correlations for mixing time, gas hold up and kLa in terms Of U-sG, U-sL, L/D and volume of gas-liquid separator were obtained and expressed separately. (C) 2008 Elsevier Ltd. All rights reserved.
机译:卧式管式生物反应器(HTLB)用于从天然气生产生物质。 HTLB(L = 2.2 m,H = 0.4 in和D = 0.03 m)中的流体力学特性(混合时间和气体滞留)和传质系数被视为设计参数的函数,即水平长度与直径之比(L / D)和气液分离器的体积(S)以及运行参数,即表观气液速度(U-sG,U-sL)。此外,还研究了不同气液流速下的流态。从实验结果可以看出,U-sL由于对混合时间的影响而对气体滞留量和k(L)a有显着影响。在不同的几何和操作因素下确定了氧气(k(L)a(O2))和甲烷(k(L)a(CH4))的体积传质系数。平均而言,用于代谢的氧气消耗量大约是甲烷的1.4倍。在气泡流动方式中,HTLB也用于生物质生产。 50%甲烷和50%氧气的气体混合物(基于干电池重量,光密度和倍增时间的结果)是生产生物质的最佳气体混合物入口。获得了混合时间,气体滞留率和kLa的经验相关性,分别以U-sG,U-sL,L / D和气液分离器的体积表示。 (C)2008 Elsevier Ltd.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号