Influence of Lubricant on Gear Failures Test Methods and Application to Gearboxes in Practice

摘要

Base oil type, oil viscosity, and additive type and content have a strong influence on typical gear failures. As it is not possible to quantify the influence of a lubricant on load-carrying capacity simply from a knowledge of the physical or chemical oil data, many test methods have been developed for the evaluation of mechanical-technological lubricant properties. Simple low-cost bench test methods often show poor correlation with practice, from both experience and systematic investigation, it can be seen that testing of gear lubricants can be performed adequately only in gear test rigs using specified test gear geometry. The standard FZG back-to-back gear test rig has been developed over many years and improved for different types of gear failure simulation. The standard FZG oil test A/8.3/90 is widely used for the evaluation of the scuffing properties of industrial gear oils. Automotive gear oils of GL4 level can be tested in the step test A10/16.6R/90, and axle oils of GL5 level in the shock test S-A10/16.6R/90. For slow-speed regimes, the C/0.05/90:120/12 wear test can be used. The influence of lubricants on the micro-pitting performance of gears can be evaluated in the GF-C/8.3/90 micropitting test. Different pitting tests are available, as single-stage (PT-C/9:10/90) or load spectrum (PT-C/LLS:HLS/90) tests. The aim of this paper is to describe the influence of the lubricant on the different failure modes in gears, how to quantify this effect in adequate test methods, and how to introduce the results of such tests as determining values of the lubricant into load-carrying capacity rating methods.