首页> 外文期刊>Transportation research >Multi-modal traffic signal control with priority, signal actuation and coordination
【24h】

Multi-modal traffic signal control with priority, signal actuation and coordination

机译:具有优先权,信号启动和协调功能的多模式交通信号控制

获取原文
获取原文并翻译 | 示例
       

摘要

Both coordinated-actuated signal control systems and signal priority control systems have been widely deployed for the last few decades. However, these two control systems are often conflicting with each due to different control objectives. This paper aims to address the conflicting issues between actuated-coordination and multi-modal priority control. Enabled by vehicle-to-infrastructure (v2i) communication in Connected Vehicle Systems, priority eligible vehicles, such as emergency vehicles, transit buses, commercial trucks, and pedestrians are able to send request for priority messages to a traffic signal controller when approaching a signalized intersection. It is likely that multiple vehicles and pedestrians will send requests such that there may be multiple active requests at the same time. A request-based mixed-integer linear program (MILP) is formulated that explicitly accommodate multiple priority requests from different modes of vehicles and pedestrians while simultaneously considering coordination and vehicle actuation. Signal coordination is achieved by integrating virtual coordination requests for priority in the formulation. A penalty is added to the objective function when the signal coordination is not fulfilled. This "soft" signal coordination allows the signal plan to adjust itself to serve multiple priority requests that may be from different modes. The priority-optimal signal timing is responsive to real-time actuations of non-priority demand by allowing phases to extend and gap out using traditional vehicle actuation logic. The proposed control method is compared with state-of-practice transit signal priority (TSP) both under the optimized signal timing plans using microscopic traffic simulation. The simulation experiments show that the proposed control model is able to reduce average bus delay, average pedestrian delay, and average passenger car delay, especially for highly congested condition with a high frequency of transit vehicle priority requests.
机译:在过去的几十年中,协调致动的信号控制系统和信号优先级控制系统都得到了广泛的部署。然而,由于不同的控制目标,这两个控制系统经常彼此冲突。本文旨在解决执行协调与多模式优先控制之间的冲突问题。通过互联车辆系统中的车辆到基础设施(v2i)通信,优先级合格的车辆(例如紧急车辆,公交车,商用卡车和行人)在接近信号灯时能够向交通信号控制器发送优先级消息请求路口。可能有多个车辆和行人将发送请求,从而可能同时存在多个活动请求。制定了基于请求的混合整数线性程序(MILP),该程序可明确容纳来自不同车辆和行人模式的多个优先级请求,同时考虑协调和车辆驱动。通过将虚拟协调请求集成到配方中来实现信号协调。当信号协调不满足时,将惩罚加到目标函数。这种“软”信号协调允许信号计划自行调整以服务可能来自不同模式的多个优先级请求。优先级最佳信号时序通过使用传统的车辆驱动逻辑来扩展相位和消除相位,从而响应非优先级需求的实时启动。在微观交通仿真下,在优化的信号时序计划下,将所提出的控制方法与实践状态的过渡信号优先级(TSP)进行比较。仿真实验表明,所提出的控制模型能够减少平均公交车延误,平均行人延误和平均乘用车延误,特别是对于交通拥挤的优先权请求频率很高的高度拥挤情况。

著录项

  • 来源
    《Transportation research》 |2014年第9期|65-82|共18页
  • 作者

    Qing He; K. Larry Head; Jun Ding;

  • 作者单位

    Department of Civil, Structural, and Environmental Engineering and Department of Industrial and Systems Engineering, University at Buffalo, The State University of New York, Buffalo, New York, 14260, United States,Environmental and Department of Industrial and Systems Engineering, University at Buffalo, The State University of New York, Buffalo, NY 14260, United States;

    Department of Systems and Industrial Engineering, University of Arizona, Tucson, AZ 85721, United States;

    Department of Systems and Industrial Engineering, University of Arizona, Tucson, AZ 85721, United States;

  • 收录信息 美国《科学引文索引》(SCI);美国《工程索引》(EI);
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

    Traffic signal control; Signal optimization; Multi-modal traffic control; Connected vehicles v2i; Transit priority; Pedestrian control;

    机译:交通信号灯控制;信号优化;多模式交通控制;联网车辆v2i;过境优先权;行人控制;

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号