Characterising polyurethane foam as impact absorber in transport packages

摘要

Transport and storage packages used for the safe transport of radioactive materials are required to satisfy IAEA regulations. One key design requirement for a radioactive material transport package is that under a 9 m regulatory drop test, containment functions are maintained. For certain payload types, such as fuel assemblies, impact loads on the payloads may need to be controlled in order to maintain spacing and confinement. To achieve all of this, detailed and accurate characterisation of the impact absorbing material is important in order to design an effective shock absorber. Polyurethane foam is an excellent energy absorbing material because it has a relatively high specific strength, a large compressive deformation, much of this at constant force, and a predictable compressive strength characteristic. Traditionally various types of wood have been used for this purpose, however foams are a more cost effective alternative, which are readily available, and can be formed and shaped easily. Some grades may have the added advantage of providing an almost isotropic crush response, combined with significant thermal protection. The general compressive strength properties of foams and their temperature dependencies are well documented by manufacturers; however, strain rate sensitivity and stiffness variation with orientation are not readily available. Hence impact compression tests for polyurethane foams for a range of densities from 56 to 320 kg m~(-3) were specified by Rolls-Royce and performed by the Health and Safety Laboratory. These tests included dynamic conditions for a range of strain rates and temperatures and a selection of orientations of the foam. Following collation of the test results, property curves were derived for the range of temperatures at which the package was expected to operate in service between -10 and + 75℃. The properties for a given specification of foam will vary within a defined tolerance range, mainly due to the variables inherent during manufacture. Hence nominal static curves were derived for each foam and a number of factors were taken into account to derive the full range of foam properties: density, compressive strength, temperature and manufacturer supplied tolerance. The net result of this work was a series of force displacement plots, depicting upper and lower bounds to account for the cumulative effects of many variables. Accounting for these upper and lower performance bounds is an essential approach in justification of any modern package design. This paper describes the characterisation and mathematical modelling of polyurethane foam for use as the main impact energy absorber in a new design of package for transporting fresh fuel. The nonlinear finite element (FE) code LS-DYNA was used to carry out simulation of the tests. The HONEYCOMB material model available in LS-DYNA was used to accurately predict the test measurements of the foam material. The properties derived for the foam were then used as input to the full FE model used for the licensing of the new package design. Full scale drop testing of the package demonstrated good correlation of deformations between test and FE model analysis, providing good validation evidence of the foam characterisation in the transport package.