...
首页> 外文期刊>Optical fiber technology >Brightness enhancement with Raman fiber lasers and amplifiers using multi-mode or multi-clad fibers
【24h】

Brightness enhancement with Raman fiber lasers and amplifiers using multi-mode or multi-clad fibers

机译:使用多模或多包层光纤的拉曼光纤激光器和放大器提高亮度

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

A large variety of high power, high brightness, rare earth doped fiber lasers have been demonstrated throughout recent years. Several obstacles, such as modal instabilities, heat removal and photo-darkening, have been identified as the limiters and have complicated the further power increase. Raman fiber sources have inherent advantages in regard to these challenges and therefore may offer a high power high brightness alternative. Up to over kW power Raman fiber laser and amplifier sources have recently been demonstrated with multimode graded index fiber (1002 W) as well as with multi-clad clad-pumped fiber (1200 W) in brightness enhancing configurations. In these schemes, the output Stokes-shifted-signal obtained higher brightness than the input pump source, due to the higher Raman gain associated with the lower order modes. A review of the recent results obtained with various configurations is presented, followed by discussion on the challenges and the paths towards further increase in power and brightness towards achieving near diffraction limited multi-kW Raman fiber sources.
机译:近年来,已经展示了各种各样的高功率,高亮度,掺稀土的光纤激光器。几种障碍,例如模态不稳定性,散热和光暗化,已被确定为限制因素,使进一步的功率增加变得复杂。拉曼纤维源在应对这些挑战方面具有固有优势,因此可以提供高功率,高亮度的替代方案。最近,已证明多模渐变折射率光纤(1002 W)以及亮度增强配置的多包层包层泵浦光纤(1200 W)可以达到高达kW以上的功率。在这些方案中,由于与低阶模式相关的拉曼增益较高,因此输出斯托克斯位移信号获得的亮度高于输入泵浦信号的亮度。本文介绍了使用各种配置获得的最新结果,然后讨论了挑战和进一步提高功率和亮度以实现接近衍射受限的多千瓦拉曼光纤源的途径。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号