A margin missed: The effect of surface oxidation on CHF enhancement in IVR accident scenarios

摘要

In severe accident mitigation approaches that aim to achieve In-Vessel Retention (IVR) the decay heat is removed from the corium by conduction through the Reactor Pressure Vessel (RPV) wall, and by flow boiling on the outer surface of the RPV. The boiling Critical Heat Flux (CHF) limit must not be exceeded to prevent RPV failure. Previous studies for prediction of CHF in IVR were predominantly based on data for stainless-steel heaters and de-ionized (DI) water coolant. However, the RPV is made of low-carbon steel, and its surface has an oxide layer that results from pre-service heat treatment as well as oxidation during service; this oxide layer renders the surface much more hydrophilic and rough with respect to an un-oxidized stainless-steel surface, which can have a significant influence on boiling heat transfer. In this study, test heaters were fabricated from low-carbon steel (grade 18MnD5), pre-oxidized in a controlled, high-temperature, humid-air environment, reproducing the prototypical surface oxides present on the outer surface of the RPV. The heaters were then tested in a flow boiling loop using the IVR water chemistry, i.e., DI water with addition of boric acid and sodium tetraborate. CHF was measured in the range of pressures (100-440 kPa), mass fluxes (180-2450 kg/m 2 s), inclination angles (30-90 degrees) and equilibrium qualifies (from - 0.020 to + 0.034) encompassing the IVR conditions. Up to 70% enhancement in CHF values was observed for pre-oxidized, low-carbon steel heaters in comparison to the stainless-steel control heaters. The effect of water chemistry on the CHF was found to be marginal. An empirical correlation fitting the CHF data for pre-oxidized, low-carbon steel surfaces with IVR water chemistry is also presented.