The fracture toughness and toughening mechanisms of wrought low carbon arc cast, oxide dispersion strengthened, and molybdenum-0.5 pct titanium-0.1 pct zirconium molybdenum plate stock

摘要

The high-temperature strength and creep resistance of low carbon arc cast (LCAC) unalloyed molybdenum, oxide dispersion strengthened (ODS) molybdenum, and molybdenum-0.5 pct titanium-0.1 pct zirconium (TZM) molybdenum have attracted interest in these alloys for various high-temperature structural applications. Fracture toughness testing of wrought plate stock over a temperature range of −150 °C to 1000 °C using bend, flexure, and compact tension (CT) specimens has shown that consistent fracture toughness results and transition temperatures are obtained using subsized 0.5T bend and 0.18T disc-CT specimens. Although the fracture toughness values are not strictly valid in accordance with all ASTM requirements, these values are considered to be a reasonable measure of fracture toughness. Ductile-to-brittle transition temperature (DBTT) values were determined in the transverse and longitudinal orientations for LCAC (200 °C and 150 °C, respectively), ODS ( DBTT, the fracture toughness values for LCAC ranged from 45 to 175 MPa√m, TZM ranged from 74 to 215 MPa√m, and the values for ODS ranged from 56 to 149 MPa√m. No temperature dependence was resolved within the data scatter for fracture toughness values between the DBTT and 1000 °C. Thin sheet toughening is shown to be the dominant toughening mechanism, where crack initiation/propagation along grain boundaries leaves ligaments of sheetlike grains that are pulled to failure by plastic necking. Specimen-to-specimen variation in the fraction of the microstructure that splits into thin sheets is proposed to be responsible for the large scatter in toughness values at test temperatures > DBTT. A finer grain size is shown to result in a higher fraction of thin sheet ligament features at the fracture surface. As a result finer grain size materials such as ODS molybdenum have a lower DBTT.