...
首页> 外文期刊>Journal of Materials Science >Synthesis of MFI-type zeolite membranes on porous α-alumina supports by wet gel crystallization in the vapor phase
【24h】

Synthesis of MFI-type zeolite membranes on porous α-alumina supports by wet gel crystallization in the vapor phase

机译:通过气相湿凝胶结晶在多孔α-氧化铝载体上合成MFI型沸石膜

获取原文
获取原文并翻译 | 示例

摘要

A new method has been developed for synthesis of MFI-type zeolite membranes on porous α-alumina supports. Using this method, a thin layer of wet-gel precursor precoated from a synthesis sol containing SiO2, tetrapropylammonium hydroxide (TPAOH), NaOH, and H2O was converted to an MFI zeolite film by vapor-phase treatment at elevated temperatures. MFI zeolite films were formed on the α-alumina substrates, respectively, in the vapor phases of TPAOH solution and an ethylenediamine(EDA)/triethylamine (TEA)/water mixture, but an amorphous material was obtained in the vapor phase of pure water. Scanning electron microscopy and helium permeation examinations before calcination showed that the MFI membrane obtained in the vapor phase of the TPAOH solution was of higher quality than that synthesized in the vapor phase of the EDA/TEA/water mixture in terms of zeolite film integrity and compactness. It was also found that the existence of the template TPA+ in the parental synthesis sol was critical to the formation of MFI zeolite under the investigated conditions. When precursor layers coated from a template-free colloidal silica system were used, the vapor-phase treatment resulted in formation of Na-P1 and ANA zeolite films, respectively, in the vapors of TPAOH solution and the EDA/TEA/water mixture. The method developed in this work has the advantages of improved controllability, minimal waste generation, and reduced chemical consumption that are desirable for large-scale production of zeolite membranes.
机译:已经开发了在多孔α-氧化铝载体上合成MFI型沸石膜的新方法。使用这种方法,从包含SiO2 ,氢氧化四丙铵(TPAOH),NaOH和H2O的合成溶胶中预涂的湿凝胶前体薄层通过气相转化为MFI沸石膜在高温下进行处理。在TPAOH溶液和乙二胺(EDA)/三乙胺(TEA)/水混合物的气相中分别在α-氧化铝基质上形成MFI沸石膜,但在纯水的气相中获得无定形材料。煅烧前的扫描电子显微镜和氦气渗透检查表明,就沸石膜的完整性和致密性而言,在TPAOH溶液的气相中获得的MFI膜的质量高于在EDA / TEA /水混合物的气相中获得的MFI膜。 。还发现,在研究条件下,亲本合成溶胶中模板TPA + 的存在对MFI沸石的形成至关重要。当使用由无模板胶体二氧化硅体系涂覆的前体层时,气相处理导致分别在TPAOH溶液和EDA / TEA /水混合物的蒸气中形成Na-P1和ANA沸石膜。在这项工作中开发的方法具有改进的可控制性,最小的废物产生和减少的化学消耗的优点,这是大规模生产沸石膜所希望的。

著录项

  • 来源
    《Journal of Materials Science 》 |2003年第5期| 979-985| 共7页
  • 作者单位

    Chemical Technology Division Oak Ridge National Laboratory;

    Metals and Ceramics Division Oak Ridge National Laboratory;

    Chemical Technology Division Oak Ridge National Laboratory;

    Chemical Technology Division Oak Ridge National Laboratory;

    Department of Chemical Engineering University of Cincinnati;

  • 收录信息
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号