首页> 外文期刊>Journal of Material Cycles and Waste Managemen >Anaerobic co-digestion of tannery waste water and tannery solid waste using two-stage anaerobic sequencing batch reactor: focus on performances of methanogenic step
【24h】

Anaerobic co-digestion of tannery waste water and tannery solid waste using two-stage anaerobic sequencing batch reactor: focus on performances of methanogenic step

机译:制革厂废水和制革厂固体废物的厌氧共消化使用两阶段厌氧顺序批处理反应器:着重于产甲烷步骤的性能

获取原文
获取原文并翻译 | 示例
           

摘要

In this study, anaerobic co-digestion of the tannery waste water (TWW) and tannery solid waste (TSW) with four TWW to TSW mixing ratios (100:0, 75:25, 50:50 and 25:75) was carried out using semi-continuous two-phase anaerobic sequencing batch reactor system under mesophilic temperature (38 +/- 2 A degrees C). During the experimental study, effluents resulted from previously optimized acidogenic reactors were used to feed subsequent methanogenic reactors and then operated at hydraulic retention time (HRT) of 20, 15 and 10 days and equivalent organic loading rate. The findings revealed that methanogenic reactor of 50:50 (TWW:TSW) treating the effluent from previously optimized acidogenic step exhibits best process performances in terms of daily biogas (415 ml/day), methane production (251 ml/day), methane content (60.5%) and COD removal efficiency (75%) when operated at HRT of 20 days. Process stability of methanogenic step also evaluated and the obtained results showed suitable pH (6.8), no VFA accumulation, i.e., VFA/Alkalinity (0.305), alkalinity (3210 mgCaCO(3)/l) and ammonia (246 mg/l with in optimum operating range). In general, improved process stability as well as performance was achieved during anaerobic co-digestion of TWW with TSW compared to mono-digestion of TWW.
机译:在这项研究中,对制革厂废水(TWW)和制革厂固体废物(TSW)进行了4种TWW与TSW混合比(100:0、75:25、50:50和25:75)的厌氧共消化。在中温温度(38 +/- 2 A摄氏度)下使用半连续两相厌氧测序间歇反应器系统。在实验研究过程中,将先前优化的产酸反应器产生的废水用于后续的产甲烷反应器,然后在20、15和10天的水力停留时间(HRT)和等效的有机负荷速率下运行。研究结果表明,以50:50(TWW:TSW)的产甲烷反应器处理先前优化的产酸步骤产生的废水,在每日沼气(415 ml /天),甲烷产量(251 ml /天),甲烷含量方面表现出最佳的工艺性能。 HRT为20天时(60.5%)和COD去除效率(75%)。还评估了产甲烷步骤的工艺稳定性,获得的结果显示合适的pH(6.8),没有VFA积累,即VFA /碱度(0.305),碱度(3210 mgCaCO(3)/ l)和氨气(246 mg / l最佳工作范围)。通常,与单消化相比,在TWW与TSW的厌氧共消化过程中,工艺稳定性和性能得到了改善。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号