Research on postprocessing of seven-axis linkage parallel kinematics machine with complicated surfaces

摘要

Because of restriction of workspace of parallel kinematics Machine ( PKM ) , 6 DOF PKM can't finish machining of workpiece with complicated surfaces under only once locating. It is necessary to fit workpiece beyond twice and to lead to low machining precision. Therefore the seven-axis linkage PKM is implemented by fixing a turntable on the worktable of the six-axis linkage PKM. However, the turntable angle decomposing problem from the CL file should be well considered. If the traditional decomposing methods are adopted, the nutation angle usually goes beyond the workspace of the machine. Therefore, according to the relation of the machine coordinate system and the workpiece coordinate system, the turntable angle decomposition algorithmic of the consistent coordinate system and the turntable angle decomposition algorithmic of the non-consistent coordinate system are developed to resolve the problem mentioned above. The turntable angle decomposition of the non-consistent coordinate system processes the decomposition which is based on the consistent coordinate system again. It calculates the initial angle of the locating workpiece, and the decomposed angle of the turntable at the machine coordinate system results in the nutation angle not going beyond workspace of the machine, thereby the decomposition process can be simplified.