首页> 外文期刊>Journal of the air & waste management association >Effect of low-density polyethylene on smoke emissions from burning of simulated debris piles
【24h】

Effect of low-density polyethylene on smoke emissions from burning of simulated debris piles

机译:低密度聚乙烯对模拟垃圾堆燃烧产生的烟雾排放的影响

获取原文
获取原文并翻译 | 示例
获取外文期刊封面目录资料

摘要

Low-density polyethylene (LDPE) plastic is used to keep piled debris from silvicultural activities-activities associated with development and care of forests-dry to enable efficient disposal by burning. The effects of inclusion of LDPE in this manner on smoke emissions are not well known. In a combustion laboratory experiment, 2-kg mixtures of LDPE and manzanita (Arctostaphylos sp.) wood containing 0, 0.25, and 2.5% LDPE by mass were burned. Gaseous and particulate emissions were sampled in real time during the entire flaming, mixed combustion phase-when the flaming and smoldering phases are present at the same time-and during a portion of the smoldering phase. Analysis of variance was used to test significance of modified combustion efficiency (MCE)-the ratio of concentrations of fire-integrated excess CO_2 to CO_2 plus CO-and LDPE content on measured individual compounds. MCE ranged between 0.983 and 0.993, indicating that combustion was primarily flaming; MCE was seldom significant as a covariate. Of the 195 compounds identified in the smoke emissions, only the emission factor (EF) of 3M-octane showed an increase with increasing LDPE content. Inclusion of LDPE had an effect on EFs of pyrene and fluoranthene, but no statistical evidence of a linear trend was found. Particulate emission factors showed a marginally significant linear relationship with MCE (0.05 < P-value < 0.10). Based on the results of the current and previous studies and literature reviews, the inclusion of small mass proportions of LDPE in piled silvicultural debris does not appear to change the emissions produced when low-moisture-content wood is burned. In general, combustion of wet piles results in lower MCEs and consequently higher levels of emissions. Implications: Current air quality regulations permit the use of burning to dispose of silvicultural piles; however, inclusion of low-density polyethyelene (LDPE) plastic in silvicultural piles can result in a designation of the pile as waste. Waste burning is not permitted in many areas, and there is also concern that inclusion of LDPE leads to toxic air emissions.
机译:低密度聚乙烯(LDPE)塑料用于防止堆积的碎屑来自造林活动-与森林开发和养护相关的活动-干燥以通过燃烧有效处置。以这种方式包含LDPE对烟雾排放的影响尚不清楚。在燃烧实验室实验中,燃烧了2千克LDPE和Manzanita(Arctostaphylos sp。)木材的混合物,其中LDPE的含量为0、0.25和2.5%。在整个燃烧,混合燃烧阶段(同时存在着燃烧和阴燃阶段)以及部分阴燃阶段中,实时采样了气体和颗粒物排放。方差分析用于检验改进的燃烧效率(MCE)的重要性-燃烧积分的过量CO_2与CO_2的浓度比加上所测单个化合物的CO-和LDPE含量。 MCE在0.983至0.993之间,表明燃烧主要是燃烧。 MCE作为协变量很少显着。在烟雾排放物中鉴定出的195种化合物中,只有3M辛烷的排放因子(EF)随LDPE含量的增加而增加。 LDPE的加入对of和荧蒽的EF有影响,但是没有发现线性趋势的统计证据。颗粒物排放因子与MCE呈线性相关(0.05 <P值<0.10)。根据当前和先前研究的结果以及文献综述,在堆积的造林碎屑中加入少量质量分数的LDPE似乎并不会改变低水分含量木材燃烧时产生的排放。通常,湿桩燃烧导致较低的MCE,因此排放水平较高。启示:现行的空气质量法规允许使用焚烧的方法来处理造林桩。但是,在造林桩中包含低密度聚乙烯(LDPE)塑料可能会导致桩被指定为废物。在许多地区都不允许焚烧废物,而且还担心包括LDPE会导致有毒的空气排放。

著录项

  • 来源
  • 作者单位

    Bourns College of Engineering, University of California, Riverside, CA, USA;

    Bourns College of Engineering, University of California, Riverside, CA, USA;

    Bourns College of Engineering, University of California, Riverside, CA, USA;

    Pacific Southwest Research Station, USDA Forest Service, Riverside, CA, USA;

    Bourns College of Engineering, University of California, Riverside, CA, USA;

    Bourns College of Engineering, University of California, Riverside, CA, USA;

    Bourns College of Engineering, University of California, 1084 Columbia Ave, Riverside, CA 92507, USA;

  • 收录信息
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号