首页> 外文期刊>Journal of advanced concrete technology >Early Age Stress Development,relaxation,and Cracking In Restrained Low W/b Ultrafine Fly Ash Mortars
【24h】

Early Age Stress Development,relaxation,and Cracking In Restrained Low W/b Ultrafine Fly Ash Mortars

机译:约束的低W / b超细粉煤灰砂浆的早期应力发展,松弛和破裂

获取原文
获取原文并翻译 | 示例
获取外文期刊封面目录资料

摘要

This paper describes an experimental study that investigated the influence of ultrafine fly ash (UFFA),a relatively new pozzolanic admixture,on the early age stress development,stress relaxation,and cracking in restrained low water-to-binder ratio (w/b) mortars due to shrinkage.The restrained ring test was used to assess the early age residual stress de-velopment in mortar ring specimens.In addition,free shrinkage strain,elastic modulus,and splitting tensile strength measurements were performed to assess the stress relaxation (creep effect) and cracking potential.It was found that the restrained mortar mixtures containing the typical fly ash (FA) (ASTM Type-F) or the ultrafine fly ash demonstrated lower levels of residual tensile stress than the control mixture.Also,both typical fly ash mortar and ultrafine fly ash mortars demonstrated a reduction in free shrinkage.In addition,an increase in the age of cracking and a decrease in stress relaxation (creep effect) were observed in the restrained mortar ring specimens containing FA or UFFA.However,at equal replacement of cement with either FA or UFFA,the delay in the age of cracking and the reduction in stress re-laxation were higher for the UFFA modified mortar.
机译:本文描述了一项实验研究,研究了相对较新的火山灰混合物超细粉煤灰(UFFA)对早期应力发展,应力松弛和受约束的低水灰比(w / b)开裂的影响。砂浆由于收缩而产生灰浆。采用约束环试验评估砂浆环试样的早期残余应力发展。此外,还进行了自由收缩应变,弹性模量和断裂拉伸强度测量,以评估应力松弛(蠕变)。结果发现,含有典型粉煤灰(FA)(ASTM Type-F)或超细粉煤灰的约束砂浆混合物显示出比对照混合物更低的残余拉伸应力。粉煤灰砂浆和超细粉煤灰砂浆的收缩率降低了。此外,在砂浆中观察到了开裂时间的增加和应力松弛(蠕变效应)的降低。经过训练的含有FA或UFFA的砂浆环试样。但是,用FA或UFFA相等地置换水泥时,UFFA改性砂浆的开裂时间延迟和应力松弛的降低更高。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号