Two-dimensional finite element thermal modeling of an oil-immersed transformer

摘要

Finite element (FE) modeling of a typical transformer indicates that the hot spot position is always on the top most part of the transformer. The hot spot temperature of winding depends on the load and the type of loading and is changed by loading. A number of the generated magnetic flux lines of windings close to their paths perpendicular to the internal channel of the windings and therefore the flux density in the middle of the channel is considerably larger than the beginning and ending of the winding. Two models of windings are employed and different temperature distributions are obtained. The computation results show that the time constant of high voltage (HV) winding is lower than that of the low voltage (LV) winding. A good agreement between the test and computed results has been achieved.