Influence of the gasket materials on the clamping pressure distribution in a PEM water electrolyzer: Bolt torques and operation mode in pre-conditioning

摘要

To keep optimally connected, all electrolysis cell elements is one of the most important design criteria. The optimal distribution of the clamping points is crucial to increasing cell performance. In this work, the compression pressure distribution inside of a 25 cm(2) PEM electrolysis cell was evaluated, using different materials: Teflon (R), Viton (R), ethylene propylene diene monomer rubber (EPDM), and nitrile rubber. Sealing material evaluation was performed taking as performance indicators: total compressed area (%) and compression pressure, for different torques applied. Pressure distribution was obtained by using pressure-sensitive films, analyzing the distribution of pressure points from three-dimensional plots (3D), and quantifying intensities of the images obtained. Results showed that pressure points distribution depends on the stiffness and thickness of the gasket materials. For a tightening torque of 3.70 N m, a pressure of 2.23 MPa is obtained with 85% of the membrane area compressed using nitrile rubber-EPDM gaskets. (C) 2021 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.