首页> 外文期刊>International Journal of Heat and Mass Transfer >Simultaneous kHz-rate temperature and velocity field measurements in the flow emanating from angled and trenched film cooling holes
【24h】

Simultaneous kHz-rate temperature and velocity field measurements in the flow emanating from angled and trenched film cooling holes

机译:从成角度的和沟槽式薄膜冷却孔发出的流中同时进行kHz速率的温度和速度场测量

获取原文
获取原文并翻译 | 示例
       

摘要

To design more efficient film cooling geometries for gas turbines, non-intrusive measurements of the flow temperature, velocity and derived quantities like the turbulent heat flux are needed in well-defined, generic flow configurations. With this aim we have applied thermographic particle image velocimetry (thermographic PIV) to investigate the flow emanating from angled and trenched cooling holes in a closed-loop optically-accessible wind tunnel facility. BAM:Eu~(2+) thermographic phosphor particles were seeded into the flow as a tracer. A pulsed high-speed UV laser was used to excite the particles and the luminescence was detected using two high-speed cameras to determine the temperature field by a two-colour ratiometric approach. The velocity field was measured using ordinary high-speed PIV. The simultaneously measured fields were sampled at a rate of 6 kHz in a vertical plane through the centreline of the symmetrical single-row cooling holes. The flowrate and temperature of the cooling air and heated main flow were chosen to achieve density and momentum flux ratios of 1.6 and 8 respectively. For these conditions the average and RMS temperature fields show that for ordinary angled holes the jet is detached from the surface. In contrast, the trenched geometry leads to a cooling film attached to the surface. However, time-resolved image sequences show instances where hot air breaks through the cooling film and almost reaches the surface. Similar image sequences for the angled holes show that the detached coolant jet becomes unstable downstream and pockets of cold air are ejected into the main flow. This intermittency may in part explain the observation that the measured turbulent heat flux is oriented towards the cold core, but deviates from the direction of the mean temperature gradient, thereby contradicting the simple gradient diffusion hypothesis commonly used in RANS simulations.
机译:为了设计用于燃气轮机的更有效的薄膜冷却几何形状,在定义明确的通用流动配置中,需要对流动温度,速度和派生量(例如湍流)进行非侵入式测量。为此,我们应用了热成像颗粒图像测速技术(热成像PIV)来研究从闭环的光学通道风洞设施中的倾斜和开槽的冷却孔流出的气流。将BAM:Eu〜(2+)热成像荧光粉粒子作为示踪剂注入流中。使用脉冲高速UV激光激发颗粒,并使用两个高速相机检测发光,通过双色比率法确定温度场。使用普通的高速PIV测量速度场。通过对称的单行冷却孔的中心线,在垂直平面上以6 kHz的速率对同时测量的磁场进行采样。选择冷却空气和加热的主流的流量和温度,以分别达到1.6和8的密度和动量通量比。对于这些条件,平均和RMS温度场表明,对于普通的成角度的孔,射流会从表面脱离。相反,开槽的几何形状导致附着在表面上的冷却膜。但是,时间分辨图像序列显示了热空气穿透冷却膜并几乎到达表面的情况。倾斜孔的相似图像序列显示,分离的冷却液射流在下游变得不稳定,冷空气囊被喷入主流中。这种间歇性可能部分解释了以下观察结果:测得的湍流通量朝向冷芯,但偏离了平均温度梯度的方向,从而与RANS模拟中常用的简单梯度扩散假设相矛盾。

著录项

相似文献

  • 外文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号