Cantilever RF-MEMS for monolithic integration with phased array antennas on a PCB

摘要

This article presents the development and operation of a novel electrostatic metal-to-metal contact cantilever radio-frequency microelectromechanical system (RF-MEMS) switch for monolithic integration with microstrip phased array antennas (PAAs) on a printed circuit board. The switch is fabricated using simple photolithography techniques on a Rogers 4003c substrate, with a footprint of 200 mu mx100 mu m, based on a 1 mu m-thick copper cantilever. An alternative wet-etching technique for effectively releasing the cantilever is described. Electrostatic and electromagnetic measurements show that the RF-MEMS presents an actuation voltage of 90V for metal-to-metal contact, an isolation of -8.7dB, insertion loss of -2.5dB and a return loss of -15dB on a 50 ohm microstrip line at 12.5GHz. For proof-of-concept, a beam-steering 2x2 microstrip PAA, based on two 1-bit phase shifters suitable for the monolithic integration of the RF-MEMS, has been designed and measured at 12.5GHz. Measurements show that the beam-steering system presents effective radiation characteristics with scanning capabilities from broadside towards 29 degrees in the H-plane.