The majority of motor specifications utilize L/sub 10/ life as the sole selection criterion for anti-friction bearings. At times, L/sub 10/ lives in excess of 100,000 hours are specified in an attempt to prevent recurring field problems when the failures are originating from nonL/sub 10/ mechanisms. In some cases, these failures occur indirectly from overspecifying L/sub 10/ life. Some general examples of this occurence are described. A successful bearing design requires the consideration of many equally important factors, which are discussed in this article.
展开▼
机译:大多数电机规格都将L / sub 10 /寿命作为减摩轴承的唯一选择标准。有时会指定L / sub 10 /的寿命超过100,000小时,以防止故障是由于非L / sub 10 /机制引起的重复出现的现场问题。在某些情况下,这些故障是由于过度指定L / sub 10 /寿命而间接发生的。描述了这种情况的一些一般示例。成功的轴承设计需要考虑许多同样重要的因素,本文将对此进行讨论。
展开▼