...
首页> 外文期刊>IEICE Transactions on Communications >Address Autoconfiguration for Event-Driven Sensor Network
【24h】

Address Autoconfiguration for Event-Driven Sensor Network

机译:事件驱动传感器网络的地址自动配置

获取原文
获取原文并翻译 | 示例
           

摘要

An event-driven sensor network composed of a large number of sensor nodes has been widely studied. A sensor node sends packets to a sink when the node detects an event. For the sink to receive packets it fails to acquire, the sink must send re-transmission requests to the sensor node. To send the requests to the sensor node using unicast, the network address of the sensor node is required to distinguish the sensor node from others. Since it is difficult to allocate the address manually to a number of nodes, a reasonable option is to use existing address autoconfiguration methods. However, the methods waste the limited energy of the sensor nodes due to using a number of control messages to allocate a permanent address to every node. In this paper, we propose an energy-efficient address autoconfiguration method for the event-driven sensor network. The proposed method allocates a temporary address only to a sensor node which detects an event, on an on-demand basis. By performing simulation studies, we evaluated the proposed method and compared it with one of the existing methods based on the number of control messages for the address allocation. The results show that the number of control messages of the proposed method is small compared to that of the existing method. We also evaluated the process time overhead of the proposed method using the implemented system. Although the proposed method has little extra overhead, the results show the processing time is short enough for practical use.
机译:由大量传感器节点组成的事件驱动传感器网络已得到广泛研究。传感器节点在检测到事件时将数据包发送到接收器。为了使接收器接收未能获取的数据包,接收器必须将重传请求发送到传感器节点。为了使用单播将请求发送到传感器节点,需要传感器节点的网络地址以将传感器节点与其他节点区分开。由于很难手动将地址分配给多个节点,因此合理的选择是使用现有的地址自动配置方法。然而,由于使用许多控制消息来将永久地址分配给每个节点,所以该方法浪费了传感器节点的有限能量。在本文中,我们提出了一种用于事件驱动传感器网络的节能地址自动配置方法。所提出的方法仅按需将临时地址仅分配给检测事件的传感器节点。通过进行仿真研究,我们评估了所提出的方法,并根据地址分配的控制消息数将其与现有方法之一进行了比较。结果表明,与现有方法相比,该方法的控制消息数量较少。我们还使用已实现的系统评估了所提出方法的处理时间开销。尽管所提出的方法几乎没有额外的开销,但结果表明处理时间足够短,可以实际使用。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号