...
首页> 外文期刊>IEEE Transactions on Nuclear Science >A Simple Capacitive Charge-Division Readout for Position-Sensitive Solid-State Photomultiplier Arrays
【24h】

A Simple Capacitive Charge-Division Readout for Position-Sensitive Solid-State Photomultiplier Arrays

机译:位置敏感型固态光电倍增管阵列的简单电容电荷除法读数

获取原文
获取原文并翻译 | 示例

摘要

A capacitive charge-division readout method for reading out a 2 × 2 array of 5 mm × 5 mm position-sensitive solid-state photomultipliers (PS-SSPM) was designed and evaluated. Using this analog multiplexing method, the 20 signals (16 position, 4 timing) from the PS-SSPM array are reduced to 5 signals (4 position, 1 timing), allowing the PS-SSPM array to be treated as an individual large-area PS-SSPM module. A global positioning approach can now be used, instead of individual positioning for each PS-SSPM in the array, ensuring that the entire light signal is utilized. The signal-to-noise ratio (SNR) and flood histogram quality at different bias voltages (27.5 V to 32.0 V at 0.5 V intervals) and a fixed temperature of 0 °C were evaluated by coupling a 6 × 6 array of 1.3 mm × 1.3 mm × 20 mm polished LSO crystals to the center of the PS-SSPM array. The timing resolution was measured at a fixed bias voltage of 31.0 V and a fixed temperature of 0 °C. All the measurements were evaluated and compared using capacitors with different values and tolerances. Capacitor values ranged from 0.051 nf to 10 nf, and the capacitance tolerance ranged from 1% to 20%. The results show that better performance was achieved using capacitors with smaller values and better capacitance tolerance. Using 0.2 nf capacitors, the SNR, energy resolution and timing resolution were 24.3, 18.2% and 8.8 ns at a bias voltage 31.0 V, respectively. The flood histogram quality was also evaluated by using a 10 × 10 array of 1 mm × 1 mm × 10 mm polished LSO crystals and a 10 × 10 array of 0.7 mm × 0.7 mm × 20 mm unpolished LSO crystals to determine the smallest crystal size resolvable. These studies showed that the high spatial resolution of the PS-SSPM was preserved allowing for 0.7 mm crystals to be identified. These results show that the capacitive charge-division analog signal proce- sing method can significantly reduce the number of electronic channels, from 20 to 5, while retaining the excellent performance of the detector.
机译:设计并评估了一种电容式电荷分割读取方法,该方法可读取2×2阵列的5 mm×5 mm位置敏感型固态光电倍增管(PS-SSPM)。使用这种模拟多路复用方法,可以将PS-SSPM阵列中的20个信号(16个位置,4个定时)减少到5个信号(4个位置,1个定时),从而将PS-SSPM阵列视为一个单独的大区域PS-SSPM模块。现在可以使用全局定位方法,而不是对阵列中每个PS-SSPM进行单独定位,从而确保利用了整个光信号。通过耦合一个6来评估在不同偏置电压(0.5V间隔为27.5 V至32.0 V)和固定温度为0 °C时的信噪比(SNR)和泛洪直方图质量。 ×6阵列的1.3毫米×1.3毫米×20毫米抛光LSO晶体位于PS-SSPM阵列的中心。在31.0 V的固定偏置电压和0 ° C的固定温度下测量定时分辨率。使用具有不同值和容差的电容器对所有测量进行评估和比较。电容值范围为0.051 nf至10 nf,电容容差范围为1%至20%。结果表明,使用具有较小值和更好电容容差的电容器可获得更好的性能。使用0.2 nf电容器,在31.0 V偏置电压下的SNR,能量分辨率和时序分辨率分别为24.3、18.2%和8.8 ns。还通过使用10×10的1 mm×1 mm×10 mm抛光LSO晶体阵列和10×10的0.7 mm×0.7 mm×20 mm未抛光LSO晶体阵列来评估洪水直方图质量,以确定最小的晶体尺寸可解决的。这些研究表明,保留了PS-SSPM的高空间分辨率,可以识别出0.7 mm的晶体。这些结果表明,电容式电荷分配模拟信号处理方法可以在保持检测器出色性能的同时,将电子通道的数量从20个减少到5个。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号