...
首页> 外文期刊>Heat transfer >Conjugate natural convection in a fluid-saturated porous enclosure with two solid vertical partitions
【24h】

Conjugate natural convection in a fluid-saturated porous enclosure with two solid vertical partitions

机译:在具有两个固体垂直隔板的流体饱和多孔外壳中共轭自然对流

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Conjugate natural convection in a fluid-saturated square porous enclosure with two solid vertical partitions of finite and equal thickness equispaced from center of enclosure is investigated in this paper. The primary objective is to attenuate the Nusselt number (Nu) and hence the heat transfer rate across a differentially heated enclosure. Darcy's model is considered. Numerical computation is performed using successive accelerated replacement and explicit scheme. Partition ratio, partition length, thermal conductivity ratio, and modified Rayleigh number are the parameters under study. Fluid flow is analyzed by observing transient changes of streamlines and isotherms for partition length 0.3-1, thermal conductivity ratio 0.5-2, partition ratio 0.1-0.3 and modified Rayleigh number 100 and 1000 where partition ratio is the ratio of distance between center of enclosure and either of the partition center to the total length of the enclosure; while Nusselt number is calculated to estimate the heat transfer rate for each configuration. It is found that, employing a solid partition within the enclosure most definitely reduces the Nusselt number. The drop in Nusselt number is more for partition length 0-0.6 after which it does show a drop in Nu but only very subtle. Further, Nu is the least for partition ratio 0.2. Also, Nusselt number is proportional to thermal conductivity ratio which is the ratio of thermal conductivity of solid to porous medium.
机译:本文研究了一个流体饱和的方形多孔壳体中的共轭自然对流,该壳体具有两个固定的垂直分隔壁,这些分隔壁与壳体中心之间的距离相等,且厚度相等且相等。主要目的是减弱Nusselt数(Nu),从而减弱跨差热外壳的传热速率。考虑了达西的模型。使用连续加速替换和显式方案进行数值计算。分配比,分配长度,导热系数和修正的瑞利数是研究的参数。通过观察流线和等温线在分隔长度0.3-1,导热系数0.5-2,分隔比0.1-0.3以及修改的瑞利数100和1000时的瞬时变化来分析流体流动,其中分隔比是外壳中心之间的距离之比任一分区中心至机柜的总长度;同时计算Nusselt数以估算每种配置的传热速率。已经发现,在外壳内采用实心隔板绝对可以减少Nusselt数。分区长度为0-0.6时,努塞尔特数的下降更多,此后确实显示出Nu的下降,但只是非常微妙。此外,对于分配比0.2,Nu最小。而且,努塞尔数与导热率之比成正比,导热率是固体与多孔介质的导热率之比。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号