首页> 外文期刊>Fuel >Precipitation of asphaltenes from solvent-diluted heavy oil and thermodynamic properties of solvent-diluted heavy oil solutions
【24h】

Precipitation of asphaltenes from solvent-diluted heavy oil and thermodynamic properties of solvent-diluted heavy oil solutions

机译:溶剂稀释重油中沥青质的沉淀和溶剂稀释重油溶液的热力学性质

获取原文
获取原文并翻译 | 示例
           

摘要

Ratios of n-heptane (hep) to toluene (tol) affect the solubility of the asphaltenes in heavy oil extraction processes. Consequently phase changes and time after mixing n-heptane and heavy oil in toluene are important for understanding produced emulsions. The kinetics of phase change when n-heptane is added to toluene-diluted heavy oils, and the thermodynamic properties of partially deasphalted heavy oils were studied. The methods used were monitoring precipitation in time using light microscopy, quantitative asphaltenes analysis by near infrared spectroscopy, refractive index and densities measurements, and calculated solubility parameters of mixtures. At critical mass ratios of hep/tol from 1.37 to 2.0 in diluted heavy oil the precipitated asphaltene particles were observed under the microscope after lag times from 2 h to instantly. Lag times were longer at low initial oil concentration. The floc growth time decreased as heavy oil concentration in toluene increased. The growth patterns in time appeared as dots to beads (strings) to clusters (fractal-like floes). Final wt percent precipitated asphaltenes vs. mass fraction (hep + tol)/heavy oil followed sigmoidal relationships. Curves showing wt percent soluble asphaltenes vs. mass fraction hep/tol after 24 h initially followed the same shape as time zero curves and diverged at the onset ratios of hep/tol. Slope for precipitated asphaltenes vs. solubility parameters curve showed a break at 16.4 MPa~(1/2). Linear correlations were established for concentrations of soluble asphaltenes in residual oils and density, for refractive index and density and for refractive index and solubility parameter. The latter correlation was in accordance with Lorenz-Lorentz theory. These equations provided a means by which oil density, refractive index and solubility parameter can be predicted when these measurements are difficult to measure practically.
机译:正庚烷(庚)与甲苯(甲苯)的比例会影响沥青质在重油萃取过程中的溶解度。因此,将正庚烷和重油在甲苯中混合后的相变和时间对于理解生成的乳液非常重要。研究了将正庚烷添加到甲苯稀释的重油中时的相变动力学,并研究了部分脱沥青重油的热力学性质。使用的方法是使用光学显微镜及时监测沉淀,通过近红外光谱法对沥青质进行定量分析,折射率和密度测量以及计算混合物的溶解度参数。在稀释重油中,Hep / Tol的临界质量比为1.37至2.0时,经过2小时到立即的滞后时间后,在显微镜下观察到沉淀的沥青质颗粒。在低初始油浓度下,滞后时间更长。随着甲苯中重油浓度的增加,絮凝物的生长时间缩短。时间上的生长模式表现为点到小珠(串)到簇(分形絮凝体)。最终的重量百分比沉淀的沥青质相对于质量分数(hep + tol)/重油遵循S形关系。表示24小时后可溶性沥青质的重量百分比与质量分数hep / tol的关系曲线最初遵循与时间零曲线相同的形状,并且在hep / tol的起始比率上发散。沉淀沥青质的斜率-溶解度参数曲线在16.4 MPa〜(1/2)处出现断裂。建立了残余油中可溶性沥青质的浓度和密度,折射率和密度以及折射率和溶解度参数的线性关系。后者的相关性符合Lorenz-Lorentz理论。这些方程式提供了一种方法,通过这些方法可以在难以实际测量时预测油的密度,折射率和溶解度参数。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号