...
首页> 外文期刊>Fine woodworking >Put a straight edge on a bowed board
【24h】

Put a straight edge on a bowed board

机译:将直边放在弓形板上

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Those of us who have wanted to straighten bowed boards on a tablesaw have seen elaborate jigs that ride along the saw fence to give defective stock a perfect, straight cut. Here's one that's cheap and easy to make. Start by screwing and gluing a 6-ft.-long board, 1 1/2 in. thick by 2 1/2 in. wide, to a 7-ft. scrap piece of hardwood plywood to make the base. The hold-downs are 3-in. muffler clamps ($3 at auto-supply stores), with wing nuts, snug-fitting nylon sleeves, and rubber feet. The threads on the opposite leg of the clamps simply drop into 3/8-in.-dia. holes in the base. These clamps flex a bit and consequently lock down tight on the stock when the wing nut is tightened. I drilled multiple holes in the base so that I can shift the clamp positions as needed.
机译:我们中那些想要拉直台锯上的弓形板的人,已经看到了沿着锯栅栏骑行的精巧夹具,可以为有缺陷的坯料提供完美的直线切割。这是一种便宜且易于制造的产品。首先将6英寸长,1 1/2英寸厚,2 1/2英寸宽的木板拧紧并粘合到7英尺。报废一块硬木胶合板做基础。压紧力为3英寸。消声器夹(在汽车用品商店出售,售价3美元),带有蝶形螺母,贴身的尼龙套和橡胶脚。夹具另一边的螺纹仅掉入3/8英寸直径。底座上的孔。这些固定夹会弯曲一些,因此在拧紧蝶形螺母时将其紧紧地锁定在库存上。我在底座上钻了多个孔,以便可以根据需要移动夹具位置。

著录项

  • 来源
    《Fine woodworking》 |2009年第206期|18-18|共1页
  • 作者

    KARL AROMAA;

  • 作者单位
  • 收录信息
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号