首页> 外文期刊>Electric power systems research >DSP-based implementation of a self-tuning fuzzy controller for three-level boost converter
【24h】

DSP-based implementation of a self-tuning fuzzy controller for three-level boost converter

机译:基于DSP的三电平升压转换器自校正模糊控制器的实现

获取原文
获取原文并翻译 | 示例
           

摘要

The three-level boost converter (TLBC) has the advantages of lower inductor current ripple and lower switch withstanding voltage compared to the classical boost converter. However, disadvantages are the requirement of capacitor voltage sensing and separate control of the mid-point voltage by the controller. Therefore, this paper proposes a self-tuning fuzzy (STF) controller for the three-level boost converter. For each operating point, a proportional integral (PI) controller is designed. The nonlinear feature of the transfer function relating the output voltage to the duty cycle is handled by using a Takagi-Sugeno fuzzy approximator (TSFA). Based on the duty cycle, the STF-PI controller can derive a control signal for any operating point. Thus, a dc bus voltage control is achieved. An additional classical PI controller is used to control the mid-point voltage. The hardware circuit of the three-level boost converter is implemented to illustrate the efficiency of the proposed approach. The hardware is divided into two parts: the dSPACE DS1104-based control circuit and the power circuit prototype developed within our laboratory. This implementation is important, particularly for the objective of methodological transfer to the industrial environment. The results verify that the proposed control strategy can yield good performance via two scenarios: (i) step variations in the reference voltage and (ii) the reference voltage tracking. (C) 2017 Elsevier B.V. All rights reserved.
机译:与传统的升压转换器相比,三电平升压转换器(TLBC)具有更低的电感器电流纹波和更低的开关耐压的优势。然而,缺点是需要电容器电压感测和由控制器单独控制中点电压。因此,本文提出了一种用于三级升压转换器的自整定模糊(STF)控制器。对于每个工作点,都设计了比例积分(PI)控制器。通过使用Takagi-Sugeno模糊逼近器(TSFA)处理将输出电压与占空比相关的传递函数的非线性特征。根据占空比,STF-PI控制器可以导出任何工作点的控制信号。因此,实现了直流总线电压控制。附加的经典PI控制器用于控制中点电压。实现了三电平升压转换器的硬件电路,以说明所提出方法的效率。硬件分为两部分:基于dSPACE DS1104的控制电路和在我们实验室内开发的电源电路原型。这种实现是重要的,特别是对于将方法学转移到工业环境的目的。结果证实了所提出的控制策略可以通过两种情况产生良好的性能:(i)参考电压的阶跃变化和(ii)参考电压跟踪。 (C)2017 Elsevier B.V.保留所有权利。

著录项

  • 来源
    《Electric power systems research》 |2017年第5期|286-297|共12页
  • 作者单位

    Cadi Ayyad Univ, Lab Elect Syst & Telecommun, BP 549,Av Abdelkarim Elkhattabi, Gueliz, Marrakesh, Morocco;

    Cadi Ayyad Univ, Lab Elect Syst & Telecommun, BP 549,Av Abdelkarim Elkhattabi, Gueliz, Marrakesh, Morocco;

    Cadi Ayyad Univ, Lab Elect Syst & Telecommun, BP 549,Av Abdelkarim Elkhattabi, Gueliz, Marrakesh, Morocco;

    Univ Chouaib Doukkali, Natl Sch Appl Sci, Lab Engn Sci Energy, Route Natl 1 Route AZEMMOUR,Km6,BP 1166, El Jadida Plateau 24002, Morocco;

    Univ Reims, CReSTIC, IUT Troyes 9,Rue Quebec CS 90396, F-10026 Troyes, France;

  • 收录信息 美国《科学引文索引》(SCI);美国《工程索引》(EI);
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

    Three-level boost converter; fuzzy self-tuning; dSPACE DS1104;

    机译:三级升压转换器;模糊自整定;dSPACE DS1104;

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号