...
首页> 外文期刊>Orthopaedic surgery >Titanium Alloy Gamma Nail versus Biodegradable Magnesium Alloy Bionic Gamma Nail for Treating Intertrochanteric Fractures: A Finite Element Analysis
【24h】

Titanium Alloy Gamma Nail versus Biodegradable Magnesium Alloy Bionic Gamma Nail for Treating Intertrochanteric Fractures: A Finite Element Analysis

机译:钛合金伽玛钉与可生物降解的镁合金仿生伽玛甲基治疗股骨转子骨折:有限元分析

获取原文

摘要

Objective To using finite element analysis to investigate the effects of the traditional titanium alloy Gamma nail and a biodegradable magnesium alloy bionic Gamma nail for treating intertrochanteric fractures. Methods Computed tomography images of an adult male volunteer of appropriate age and in good physical condition were used to establish a three-dimensional model of the proximal femur. Then, a model of a type 31A1 intertrochanteric fracture of the proximal femur was established, and the traditional titanium alloy Gamma nails and biodegradable magnesium alloy bionic Gamma nails were used for fixation, respectively. The von Mises stress, the maximum principal stress, and the minimum principal stress were calculated to evaluate the effect of bone ingrowth on stress distribution of the proximal femur after fixation. Results In the intact model, the maximum stress was 5.8 MPa, the minimum stress was ?11.7 MPa, and the von Mises stress was 11.4 MPa. The maximum principal stress distribution of the cancellous bone in the intact model appears in a position consistent with the growth direction of the principal and secondary tensile zones. After traditional Gamma nail healing, the maximum stress was 32 MPa, the minimum stress was ?23.5 MPa, and the von Mises stress was 31.3 MPa. The stress concentration was quite obvious compared with the intact model. It was assumed that the nail would biodegrade completely within 12?months postoperatively. The maximum stress was 18.7?MPa, the minimum stress was ?12.6 MPa, and the von Mises stress was 14.0 MPa. For the minimum principal stress, the region of minimum stress value less than ?10 MPa was significantly improved compared with the traditional titanium alloy Gamma nail models. Meanwhile, the stress distribution of the bionic Gamma nail model in the proximal femur was closer to that of the intact bone, which significantly reduced the stress concentration of the implant. Conclusion The biodegradable magnesium alloy bionic Gamma nail implant can improve the stress distribution of fractured bone close to that of intact bone while reducing the risk of postoperative complications associated with traditional internal fixation techniques, and it has promising clinical value in the future.
机译:目的利用有限元分析来研究传统钛合金γ钉和可生物降解的镁合金仿生γ纤维纤维纤维纤维凝固治疗梭菌骨折的影响。方法采用适当年龄的成年男性志愿者和良好物理状况的计算断层扫描图像用于建立近端股骨的三维模型。然后,建立了近端股骨的31A1型次间骨折的模型,并且传统的钛合金γ钉和可生物降解的镁合金仿生γ钉子分别用于固定。计算von误导应力,最大的主应力和最小主要压力,以评估骨骼注入对固定后近端股骨应激分布的影响。结果在完整的模型中,最大应力为5.8MPa,最小应力是?11.7MPa,von误胁迫是11.4MPa。完整模型中的松质骨的最大主应力分布出现在与主要和二级拉伸区的生长方向一致的位置。经过传统的伽玛钉愈合后,最大应力为32MPa,最小应力是23.5MPa,von误解率为31.3MPa。与完整模型相比,应力浓度非常明显。假设钉子将在术后12个月内完全生物降解。最大应力为18.7?MPa,最小应力是α12.6MPa,von误胁迫为14.0MPa。对于最小的主应力,与传统的钛合金伽玛指甲模型相比,最小应力值小于α10MPa的区域。同时,近端股骨中的仿生伽马指甲模型的应力分布更接近完整的骨骼,这显着降低了植入物的应力浓度。结论可生物降解的镁合金仿生玉米甲锯植入物可以改善骨折骨的应力分布接近完整骨的骨折骨的应力分布,同时降低了与传统内部固定技术相关的术后并发症的风险,并在未来临床价值。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号