...
首页> 外文期刊>Journal of Clinical and Diagnostic Research >Effect of Different Ferrule Length on Fracture Resistance of Endodontically Treated Teeth: An In vitro Study ZC49-ZC52
【24h】

Effect of Different Ferrule Length on Fracture Resistance of Endodontically Treated Teeth: An In vitro Study ZC49-ZC52

机译:不同套圈长度对牙本质治疗牙齿抗断裂性的影响:ZC49-ZC52的体外研究

获取原文

摘要

Introduction: A ferrule has been described as a key element of tooth preparation when using a post and a core. It is a vertical band of tooth structure at the gingival aspect of crown preparation. It lessens the stress transmission to the root which is due to forces from posts or bending during seating of the post. The incorporation of a ferrule can help to withstand the forces of occlusion, preserve the hermetic seal of the luting cement, and minimize the concentration of stresses at the junction of post and core.Aim: To evaluate and compare the effect of ferrule length on fracture resistance of endodontically treated mandibular premolar teeth, restored with prefabricated glass fiber post luted with resin cement, composite core and a full coverage metal crown.Materials and Methods: Forty freshly extracted mandibular premolars were treated endodontically. They were randomly divided into four groups according to their ferrule height: 3 mm, 2 mm, 1 mm and 0 mm (no ferrule). All specimens were restored with prefabricated glass fibre posts (Reforpost, Angelus) and composite resin (Filtek? Z250xt). Standardized preparation was done on each specimen to receive a cast metal crown. The specimens were thermocycled and compressive static load at a crosshead speed of 1 mm/min was applied at an angle of 30° on lingual incline of buccal cusp of the crown until failure occurred. The load (N) at failure and mode of failure were recorded. Statistical analysis was performed with Kruskal Wallis test.Result: Fracture resistance values among the groups was found to be statistically significant (p<0.001). The 3 mm ferrule group had significantly higher failure load (971.99+133.07) compared to 2 mm (848.84+109.60), 1 mm (714.64+133.89) and 0 mm ferrule groups (529.36+119.95). More favourable failure modes were observed in almost all groups.Conclusion: The results of this study showed that fracture resistance of endodontically treated teeth increases as ferrule length increases.
机译:简介:套圈已被描述为使用立柱和铁芯时牙齿准备的关键要素。它是在准备牙冠的牙龈方面垂直排列的牙齿结构。它减少了应力传递到根部,该应力传递是由于来自柱的力或柱安装期间弯曲而引起的。套圈的结合可以帮助抵抗咬合力,保持水泥胶的气密性,并最大程度地减少桩和岩心交界处的应力集中。目的:评估和比较套圈长度对断裂的影响经牙髓治疗的下颌前磨牙的抗磨性,并用树脂水泥,复合材料芯和全覆盖的金属牙冠冲切的预制玻璃纤维修复。材料与方法:对40颗新鲜提取的下颌前磨牙进行牙髓治疗。根据插芯高度将它们随机分为四组:3 mm,2 mm,1 mm和0 mm(无插芯)。用预制的玻璃纤维桩(Reforpost,Angelus)和复合树脂(Filtek?Z250xt)修复所有标本。在每个样品上进行标准化准备,以接收铸金属胎冠。将样品进行热循环,并以1mm / min的十字头速度以30°的角度施加压缩静载荷,对冠颊颊尖的舌侧倾斜,直到发生破坏。记录失效时的载荷(N)和失效模式。用Kruskal Wallis检验进行统计分析。结果:发现各组之间的断裂阻力值具有统计学意义(p <0.001)。 3 mm套圈组的故障载荷(971.99 + 133.07)明显高于2 mm(848.84 + 109.60),1 mm(714.64 + 133.89)和0 mm套圈组(529.36 + 119.95)。几乎在所有组中都观察到了更有利的失效模式。结论:这项研究的结果表明,经过牙髓治疗的牙齿的断裂阻力随着套圈长度的增加而增加。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号