...
首页> 外文期刊>Astronomy and astrophysics >The W43-MM1 mini-starburst ridge, a test for star formation efficiency models
【24h】

The W43-MM1 mini-starburst ridge, a test for star formation efficiency models

机译:W43-MM1小型星暴山脊,对恒星形成效率模型的测试

获取原文
           

摘要

Context. Star formation efficiency (SFE) theories are currently based on statistical distributions of turbulent cloud structures and a simple model of star formation from cores. They remain poorly tested, especially at the highest densities. Aims. We investigate the effects of gas density on the SFE through measurements of the core formation efficiency (CFE). With a total mass of ~2 × 104?M⊙, the W43-MM1 ridge is one of the most convincing candidate precursors of Galactic starburst clusters and thus one of the best places to investigate star formation. Methods. We used high-angular resolution maps obtained at 3 mm and 1 mm within the W43-MM1 ridge with the IRAM Plateau de Bure Interferometer to reveal a cluster of 11 massive dense cores, and, one of the most massive protostellar cores known. A Herschel column density image provided the mass distribution of the cloud gas. We then measured the “instantaneous” CFE and estimated the SFE and the star formation rate (SFR) within subregions of the W43-MM1 ridge. Results. The high SFE found in the ridge (~6% enclosed in ~8 pc3) confirms its ability to form a starburst cluster. There is, however, a clear lack of dense cores in the eastern part of the ridge, which may be currently assembling. The CFE and the SFE are observed to increase with volume gas density, while the SFR per free fall time steeply decreases with the virial parameter, αvir. Statistical models of the SFR may describe the outskirts of the W43-MM1 ridge well, but struggle to reproduce its inner part, which corresponds to measurements at low αvir. It may be that ridges do not follow the log-normal density distribution, Larson relations, and stationary conditions forced in the statistical SFR models.
机译:上下文。目前,恒星形成效率(SFE)理论是基于湍流云结构的统计分布以及由核形成恒星的简单模型。它们仍然测试不佳,尤其是在最高密度的情况下。目的我们通过测量岩心形成效率(CFE)来研究气体密度对SFE的影响。 W43-MM1脊的总质量约为2×104?M⊙,是银河星爆星团最有说服力的候选前兆之一,因此也是研究恒星形成的最佳场所之一。方法。我们使用IRAM高原德布尔干涉仪在W43-MM1脊内的3mm和1mm处获得的高角度分辨率图,揭示了由11个质量大的密集核以及已知的质量最大的原恒星核之一组成的簇。赫歇尔柱密度图像提供了云气的质量分布。然后,我们测量了“瞬时” CFE,并估计了W43-MM1脊次区域内的SFE和恒星形成率(SFR)。结果。在山脊中发现的高SFE(约6%封闭在〜8 pc3中)证实了其形成星爆星团的能力。但是,在山脊的东部地区显然没有致密的岩心,这些岩心目前可能正在聚集。观察到CFE和SFE随着气体体积密度的增加而增加,而每个自由落体时间的SFR随病毒参数αvir急剧下降。 SFR的统计模型可以很好地描述W43-MM1脊的边缘,但是很难再现其内部,这与在低αvir下的测量相对应。可能是脊不遵循对数正态密度分布,拉森关系和统计SFR模型中强制施加的静止条件。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号