Quantitative and qualitative evaluation of resin-dentin bond strengths: in vitro effects of surface treatment with metalloproteinase inhibitors

摘要

AIM: The objective of this study was to evaluate the use of MMPs inhibitors (chlorhexidine and EDTA) in bond strength and quality of the hybrid layer of adhesive restorations in normal dentin using two ethanol-based total-etch adhesive systems. MATERIAL AND METHODS: Thirty-two extracted human molars were coronally sectioned and randomly divided into 8 groups (n=4), depending on the surface pre-treatment and adhesive system used. The total-etch adhesive systems Single Bond 2 (2-step) and Adper Scotchbond Multi-Purpose Plus (3-step) were used as follows: 1) according to manufacturer's instructions (etching with 37% phosphoric acid (H 3 PO 4 ) for 15 s); 2) etching with H 3 PO 4 for 15 s, followed by 2% chlorhexidine for 120 s; 3) etching with 0.1 M EDTA for 60 s; 4) etching with 0.1 M EDTA followed by 2% chlorhexidine for 120 s. Teeth were incrementally restored with composite resin (Filtek Z350XT). After water storage for 24 h, teeth were double-sectioned, yielding stick specimens of 1.0 mm2 bonded area, and then subjected to microtensile bond strength (MTBS) test at 0.5 mm/min. Additional specimens were gold-sputtered to be analyzed under scanning electron microscopy (SEM). Data (in Mega Pascal) were subjected to Kruskal-Wallis and Dunn (p <0.05) tests. RESULTS: The etching protocol (37% H 3 PO 4 or EDTA) interfered with hybrid layer formation, monomer penetration and the MTBS. Funnel shaped resin tags were observed when dentin was etched with 37% H 3 PO 4 . In these specimens, MTBS were also higher. EDTA conditioning produced thin hybrid layers and smaller MTBS, regardless the adhesive system used. Chlorhexidine application after conditioning resulted in no apparent differences between both evaluated techniques (37% H 3 PO 4 or EDTA). CONCLUSION: The use of chlorhexidine as a MMP inhibitor does not alter immediate bond strength values and does not interfere with hybrid layer formation.