首页> 外文期刊>Journal of Science and Technology of Agriculture and Natural Resources >Draft, Specific Draft and Drawbar Power Requirement of Chisel Plow at Different Levels of Soil Moisture Content and Plowing Depth
【24h】

Draft, Specific Draft and Drawbar Power Requirement of Chisel Plow at Different Levels of Soil Moisture Content and Plowing Depth

机译:不同含水率和耕深水平下凿耕机的吃水,特定吃水和牵引力要求

获取原文
           

摘要

The effects of three levels of soil moisture content (8-10, 10-12 and 12-14% d.b.) and three levels of plowing depth (15, 20 and 25 cm) on draft, specific draft and drawbar power requirement of a 7-shank chisel plow in a clay loam soil were investigated. The experimental design was a randomized complete block design with a 3×4 factorial. The effect of plowing depth on all of the parameters mentioned was highly significant. Implement draft and drawbar power requirement both increased with plowing depth, whereas a decreasing trend of specific draft with depth was observed. Soil moisture content had no significant effect on draft and specific draft of chisel plow in the range of moisture contents studied, though both parameters were minimized at 10-12% m.c. At this moisture level, the drawbar power requirement showed a significant reduction comparing with the other two moisture levels. This indicated that the soil was close to its optimum friability at this moisture content. Soil penetrometer readings, taken before and after plowing, indicated the existence of a hardpan from about 8 to 20 cm below the surface which was broken by chisel tines, but another hard layer formed under the plowing depth by the chisel points. Comparison of the results from the present study with those from the previously published works on chisel plow draft at similar plowing depths showed that the values obtained for draft and specific draft were acceptably close to those previous investigators. Also, a comparison with the findings of Loghavi and Moradi on moldboard plow draft under similar conditions confirmed the reports of previous investigators to the effect that a chisel plow requires approximately one-half of the draft of a moldboard plow with the same working width and depth. Keywords: Draft, Specific draft, Drawbar power, Chisel plow Full-Text Type of Study: Research | Subject: Ggeneral Received: 2008/01/9 Related Websites Scientific Publications Commission - Health Ministry Scientific Publications Commission - Science Ministry Yektaweb Company Site Keywords ?????, Academic Journal, Scientific Article, ???? ????? ??, ???? ????? ??, ???? ????? ??, ???? ????? ??, ???? ????? ??, ???? ????? ??, ???? ?? Vote ? 2015 All Rights Reserved | JWSS - Isfahan University of Technology
机译:三层土壤水分含量(8-10%,10-12和12-14%db)和三层耕深深度(15、20和25 cm)对吃水,特定吃水和牵引力的要求为7研究了粘土壤土中的小腿凿犁。实验设计是具有3×4阶乘的随机完整块设计。刨深对上述所有参数的影响非常显着。机具吃水和牵引力的要求均随耕深的增加而增加,而观察到的具体吃水随深度的减小趋势。在研究的含水量范围内,土壤水分含量对凿犁的吃水深度和比吃水量没有显着影响,尽管在10-12%m.c时两个参数都最小。在此湿度水平下,与其他两个湿度水平相比,牵引杆功率要求显示出显着降低。这表明在该含水量下土壤接近其最佳脆碎性。在耕作前后,土壤渗透仪的读数表明,在凿子下方破裂的表面以下约8至20 cm处存在一个硬盘,但凿子在耕作深度下形成了另一个硬层。将本研究的结果与先前发表的关于类似犁深的凿子犁p的研究结果进行比较,结果表明,吃水和特定吃水的值与以前的研究人员相近。此外,与Loghavi和Moradi在类似条件下在刮土机犁draft上的发现进行比较,证实了先前研究者的报告,即凿子犁需要大约相同工作宽度和深度的刮土机犁the的一半。 。关键字:吃水,特定吃水,牵引力,凿子犁全文研究类型:研究|主题:一般收稿日期:2008/01/9相关网站科学出版物委员会-卫生部科学出版物委员会-科学部Yektaweb公司网站关键字??????,Academic Journal,Scientific Article,???? ?????? ??,???? ?????? ??,???? ?????? ??,???? ?????? ??,???? ?????? ??,???? ?????? ??,???? ??投票吗? 2015版权所有| JWSS-伊斯法罕工业大学

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号