Combination of modified Yld2000-2d and Yld2000-2d in anisotropic pressure dependent sheet metals

摘要

In the current research to model anisotropic asymmetric sheet metals a new non-AFR criterion is presented. In the new model, Modified Yld2000-2d proposed by Lou et al. (2013) is considered as yield function and Yld2000-2d proposed by Barlat et al. (2003) is considered as plastic potential function. To calíbrate the presented criterion, the yield function which is a pressure dependent criterion requiers ten directional yield stresses such as uniaxial tensile stresses in three directions of 0o, 45o, 90o, uniaxial compressive yield stresses in six directions of 0o, 15o, 30o, 45o, 75o, 90o from the rolling direction along with biaxial yield stress. Moreover, the plastic potential function which is a pressure indepedent criterion needs eight experimental data points such as tensile R-values in seven directions of 0o, 15o, 30o, 45o, 60o, 75o, 90o from the rolling direction and also biaxial tensile R-value. Finally with comparing the obtained results with experimental data points, it is shown that the presented non-AFR criterion predicts compressive yield stress, biaxial tensile yield stress and R-values more accurately than Modified Yld2000-2d and it would be considered as a new criterion for anisotropic asymmetric metals.