...
首页> 外文期刊>Asian spine journal. >Morphometric Evaluation of Occipital Condyles: Defining Optimal Trajectories and Safe Screw Lengths for Occipital Condyle-Based Occipitocervical Fixation in Indian Population
【24h】

Morphometric Evaluation of Occipital Condyles: Defining Optimal Trajectories and Safe Screw Lengths for Occipital Condyle-Based Occipitocervical Fixation in Indian Population

机译:枕骨的形态计量学评价:为印度人口中基于枕骨dy的枕骨颈固定术定义最佳轨迹和安全螺钉长度

获取原文
   

获取外文期刊封面封底 >>

       

摘要

Study Design Computed tomographic (CT) morphometric analysis. Purpose To assess the feasibility and safety of occipital condyle (OC)-based occipitocervical fixation (OCF) in Indians and to define anatomical zones and screw lengths for safe screw placement. Overview of Literature Limitations of occipital squama-based OCF has led to development of two novel OC-based OCF techniques. Methods Morphometric analysis was performed on the OCs of 70 Indian adults. The feasibility of placing a 3.5-mm-diameter screw into OCs was investigated. Safe trajectories and screw lengths for OC screws and C0–C1 transarticular screws without hypoglossal canal or atlantooccipital joint compromise were estimated. Results The average screw length and safe sagittal and medial angulations for OC screws were 19.9±2.3 mm, ≤6.4°±2.4° cranially, and 31.1°±3° medially, respectively. An OC screw could not be accommodated by 27% of the population. The safe sagittal angles and screw lengths for C0–C1 transarticular screw insertion (48.9°±5.7° cranial, 26.7±2.9 mm for junctional entry technique; 36.7°±4.6° cranial, 31.6±2.7 mm for caudal C1 arch entry technique, respectively) were significantly different than those in other populations. The risk of vertebral artery injury was high for the caudal C1 arch entry technique. Screw placement was uncertain in 48% of Indians due to the presence of aberrant anatomy. Conclusions There were significant differences in the metrics of OC-based OCF between Indian and other populations. Because of the smaller occipital squama dimensions in Indians, OC-based OCF techniques may have a higher application rate and could be a viable alternative/salvage option in selected cases. Preoperative CT, including three-dimensional-CT-angiography (to delineate vertebral artery course), is imperative to avoid complications resulting from aberrant bony and vascular anatomy. Our data can serve as a valuable reference guide in placing these screws safely under fluoroscopic guidance.
机译:研究设计计算机断层扫描(CT)形态分析。目的评估印地安人基于枕骨((OC)的枕颈固定(OCF)的可行性和安全性,并定义解剖区域和螺钉长度,以安全地放置螺钉。文献概述基于枕鳞的OCF的局限性导致了两种新颖的基于OC的OCF技术的发展。方法对70名印度成年人的OC进行形态计量学分析。研究了将3.5毫米直径的螺钉放入OC中的可行性。估计了OC螺钉和C0–C1跨关节螺钉的安全轨迹和螺钉长度,没有舌下沟或寰枕关节受损。结果OC螺钉的平均螺钉长度,安全矢状和内侧角度分别为19.9±2.3 mm,颅骨≤6.4°±2.4°和内侧31.1°±3°。 OC螺丝无法容纳27%的人口。 C0–C1经关节螺钉置入的安全矢状角和螺钉长度(颅骨入路技术为48.9°±5.7°颅骨,交界入路技术为26.7±2.9 mm;颅骨C1足弓入路技术为36.7°±4.6°颅骨,31.6±2.7 mm )与其他人群的差异显着。尾椎C1弓进入技术会导致椎动脉损伤的风险很高。由于解剖结构异常,在48%的印度人中螺钉放置不确定。结论在印度人和其他人群中,基于OC的OCF指标存在显着差异。由于印第安人的枕鳞较小,基于OC的OCF技术可能具有较高的应用率,在某些情况下可能是可行的替代/挽救选择。术前CT包括三维CT血管造影(以描绘椎动脉的走向),必须避免因畸形的骨骼和血管解剖结构而引起的并发症。我们的数据可以作为将这些螺钉安全地放在荧光镜检查下的有价值的参考指南。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号