This paper deals with the motion control of the end effector of a 2-DOF linkage type underactuated robotic manipulator. A simulation procedure is implemented for the motion control in which actuation and braking actions were applied on the two joints of the manipulator subsequently,? hence moving the end effector in a point to point manner through the desired path. From the results obtained, it was found that the percentage error in trajectory mainly does not exceed (1%). In some specific points on the trajectory, error reached its maximum value which was found to be (3.64%). In general, these error values are almost acceptable, although an effort will be achieved in future work to reduce this error and improve the design.
展开▼
