...
首页> 外文期刊>Computer Communications >Flow level performance evaluation in mobile networks: Analytical modeling and empirical validation
【24h】

Flow level performance evaluation in mobile networks: Analytical modeling and empirical validation

机译:移动网络中的流量级别性能评估:分析模型和经验验证

获取原文
获取原文并翻译 | 示例
           

摘要

The purpose of this paper is to identify, through empirical validation, the best analytical model for QoS and capacity estimation in mobile data networks. We first present two different sets of models that have been proposed in the literature: the infinite source, Erlang-like models and the finite source, Engset-like models. While the former models are widely developed and adapted to mobile networks, the latter are less used in the mobile context. We thus derive novel analytical models to complete the finite source theory before moving to the comparison of the different models. We make use of network measurements originating from an HSPA network and compare the modeled performance with the observed one, for each of the available analytical models. Our results show that a Processor Sharing analysis that takes as cell capacity the harmonic average of the achievable throughputs and as traffic inputs the volumes generated in each CQI, gives results that are close to the field measurements. As of the finite source models, we observed a good match on some cells and a mismatch on other cells. This is due to the difficulty of extracting traffic parameters from the field. However, finite source models have a better predictive power than infinite source models, as their traffic characteristics can more easily be linked to changes in the network such as the introduction of new services or new devices. (C) 2017 Elsevier B.V. All rights reserved.
机译:本文的目的是通过经验验证来确定移动数据网络中QoS和容量估计的最佳分析模型。我们首先介绍文献中提出的两组不同的模型:无限源(类似于Erlang的模型)和有限源(类似于Engset的模型)。尽管前者模型得到了广泛的开发并适合于移动网络,但后者在移动环境中的使用却较少。因此,在进行不同模型的比较之前,我们得出了新颖的分析模型以完成有限源理论。对于每种可用的分析模型,我们利用源自HSPA网络的网络度量,并将建模的性能与观察到的性能进行比较。我们的结果表明,处理器共享分析将单元吞吐量的谐波平均值作为可达到的吞吐量的谐波平均值,并且当业务量输入每个CQI中生成的体积时,得出的结果与现场测量结果相近。从有限源模型开始,我们观察到某些单元格上的匹配良好,而其他单元格上则不匹配。这是由于难以从现场提取交通参数。但是,有限源模型比无限源模型具有更好的预测能力,因为它们的流量特性可以更轻松地与网络的变化(例如引入新服务或新设备)相关联。 (C)2017 Elsevier B.V.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号