...
首页> 外文期刊>Communications and network >Optimal Number of Relays in Cooperative Communication in Wireless Sensor Networks
【24h】

Optimal Number of Relays in Cooperative Communication in Wireless Sensor Networks

机译:无线传感器网络中协作通信中的最佳中继数

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Wireless Sensor Networks (WSN) typically consist of resource constrained micro sensors that organize itself into multi-hop wireless network. Sensors collect data and send it directly, or through intermediate hops in cooperative communication system, to the collection point. These sensors are powered up by batteries, for which the replacement or recharging is very difficult. With finite energy, we can transmit a finite amount of information. Therefore, minimizing the power consumption for data transmission becomes a most important design consideration for wireless sensor networks. In this paper, we discuss the optimal power consumption in cooperative wireless sensor network that are placed on a grid. We study different cases for the optimal power consumption in such grids by varying the grid distance and number of nodes in the grid. We assume the cases of grids from 2×2 up to 5×5in increasing complexity of calculations. The results show that the optimal path that consumes the least power is the path along the diagonal using of the grid when the source and the destination and the furthest two nodes in the grid. This path takes intermediate nodes (relays) along it based on some threshold distances. For example, in 5 × 5 cases; the first threshold between the direct distance and between using one relay in the middle is 31.6 m the second threshold distance is 63.3 m after which using three relays is the best in power consumption between the source and the destination.
机译:无线传感器网络(WSN)通常由资源受限的微型传感器组成,这些传感器将自身组织成多跳无线网络。传感器收集数据并将其直接发送或通过协作通信系统中的中间跃点发送到收集点。这些传感器由电池供电,更换或充电非常困难。利用有限的能量,我们可以传输有限的信息。因此,最小化数据传输的功耗成为无线传感器网络最重要的设计考虑因素。在本文中,我们讨论了放置在网格上的协作无线传感器网络中的最佳功耗。我们通过改变网格距离和网格中节点的数量,研究了不同情况下此类网格的最佳功耗。我们假设从2×2到5×5的网格情况会增加计算的复杂性。结果表明,功耗最小的最优路径是当源和目标以及网格中最远的两个节点时沿着网格使用对角线的路径。该路径基于一些阈值距离沿其获取中间节点(继电器)。例如,在5×5的情况下;直接距离与中间使用一个继电器之间的第一阈值是31.6 m,第二阈值距离是63.3 m,之后使用三个继电器在源和目标之间的功耗方面是最好的。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号